Transition Networks SGETF1025-100, SGETF1013-100, SGETF1018-100, SGETF1015-100, SGETF1017-100 User Manual

...

COMPLIANCE INFORMATION

UL Listed C-UL Listed (Canada) CISPR/EN55022 Class A EN55024

FCC Regulations

This equipment has been tested and found to comply with the limits for a class A digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the user will be required to correct the interference at the user’s own expense.

Canadian Regulations

This digital apparatus does not exceed the Class A limits for radio noise for digital apparatus set out on the radio interference regulations of the Canadian Department of Communications.

Le présent appareil numérique n'émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la class A prescrites dans le Règlement sur le brouillage radioélectrique édicté par le ministère des Communications du Canada.

European Regulations

Warning

This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.

Achtung !

Dieses ist ein Gerät der Funkstörgrenzwertklasse A. In Wohnbereichen können bei Betrieb dieses Gerätes Rundfunkstörungen auftreten, in weichen Fällen der Benutzer für entsprechende Gegenmaßnahmen werantwortlich ist.

Attention !

Ceci est un produit de Classe A. Dans un environment domestique, ce produit risque de créer des interférences radioélectriques, il appartiendra alors à l’utilsateur de prende les measures spécifiques appropriées

Trademark Notice

All registered trademarks and trademarks are the property of their respective owners.

© 2001 TRANSITION Networks. All rights reserved. No part of this work may be reproduced or used in any form or by any means – graphic, electronic, or mechanical – without written permission from TRANSITION Networks.

Printed in the U.S.A. 33197.C

CAUTION: RJ connectors are NOT INTENDED FOR CONNECTION TO THE PUBLIC TELEPHONE NETWORK. Failure to observe this caution could result in damage to the public telephone network.

Der Anschluss dieses Gerätes an ein öffentlickes Telekommunikationsnetz in den EG-Mitgliedstaaten verstösst gegen die jeweligen einzelstaatlichen Gesetze zur Anwendung der Richtlinie 91/263/EWG zur Angleichung der Rechtsvorschriften der Mitgliedstaaten über Telekommunikationsendeinrichtungen einschliesslich der gegenseitigen Anerkennung ihrer Konformität.

TRANSITION Networks SGETF10xx series Gigabit Ethernet™media converters connect 1000BASE-TX shielded or unshielded twisted-pair copper cable to 1000BASE-SX or 1000BASE-LX

multimode or singlemode fiber-optic cable.

1000BASE-TX to 1000BASE-SX/LX

Media Converters

SGETF10xx-100

USER’S GUIDE

SGETF1013-100

Provides an RJ-45 twisted-pair copper 1000BASE-T connector and an RX (receive) and TX (transmit) SC connector to 850 nm 1000BASE-SX multimode fiber-optic cable.

SGETF1014-100

Provides an RJ-45 twisted-pair copper 1000BASE-T connector and an RX (receive) and TX (transmit) SC connector to 1300 nm 1000BASE-LX singlemode fiber-optic cable.

SGETF1015-100

Provides an RJ-45 twisted-pair copper 1000BASE-T connector and an RX (receive) and TX (transmit) SC connector to 1300 nm 1000BASE-LX singlemode fiber-optic cable.

SGETF1017-100

Provides an RJ-45 twisted-pair copper 1000BASE-T connector and an RX (receive) and TX (transmit) SC connector to 1550 nm 1000BASE-LX singlemode fiber-optic cable.

SGETF1018-100

Provides an RJ-45 twisted-pair copper 1000BASE-T connector and an RX (receive) and TX (transmit) MT-RJ connector to 850 nm 1000BASE-SX multimode fiber-optic cable.

SGETF1025-100

Provides an RJ-45 twisted-pair copper 1000BASE-T connector and an RX (receive) and TX (transmit) MT-RJ connector to 1300 nm 1000BASE-LX singlemode fiber-optic cable.

SGETF10xx in the Network . . . . . . . .2

Installation . . . . . . . . . . . . . . . . . . . .2

Operation . . . . . . . . . . . . . . . . . . . . .4

Fault Isolation and Correction . . . . .5

Cable Specifications . . . . . . . . . . . . .6

Technical Specifications . . . . . . . . . .7

Compliance Information . . . . . . . . . .8

9-12 VDC INPUT

Ethernet

1000BaseT to 1000BaseSX/LX

1000BASE-T Copper

1000Base-T

Media Converter

1000Base-SX/LX

1000BASE-SX/LX Fiber

SGETF10xx IN THE NETWORK

Install two SGETF10xx series media converters in series to extend, over fiber, the distance between two 1000BASE-TX devices.

Use one SGETF10xx media converter to connect a 1000BASE-TX terminal device and a 1000BASE-SX/LX hub, switch, or router.

NOTE: A TRANSITION Networks stand-alone media converter can be installed in series with a TRANSITION Networks chassis media converter that has a related model number, such as an SGETF10xx with a CGETF10xx.

INSTALLATION

Set 4-Position Switch

Use small flatblade screwdriver or similar device to set recessed switches. Refer to drawing for four-position switch locations.

Full/Half-Duplex Advertisement (UP=Enabled) Allows full-duplex mode. (DOWN) Allows half-duplex mode.

Pause Advertisement (UP=Enabled)

Allows auto-negotiation pause. (DOWN) Allows NO auto-negotiation pause.

NOTE: If the Pause feature is present on all network devices attached to the media converter(s), enable Pause on the media converter(s). Otherwise, disable Pause on the media converter(s).

LPT (UP=Enabled) Allows a fault EITHER on the copper OR on the fiber side of the media coverter to stop signal and data transmission on the other side. (DOWN) Disables LPT.

TECHNICAL SPECIFICATIONS

Standards IEEE 802.3ab, IEEE 802.3 1998 Data Rate 1000 Mb/s

Dimensions 3.4" x 0.86" x 5.0" (86mm x 22mm x 127mm) Weight 8 oz (approximate) Delay 300 nsec

Power Consumption 6.5 Watts Power Supply Requirements Replace power supply with only the equivalent

input rating (see below) and output rating (unregulated 9-24VDC, 5.5W).

TN PN Requirement Location

12 V, 1.5 A

3507 240 volts, 50 hertz United Kingdom 3342 230 volts, 50 hertz Europe 3340 120 volts, 60 hertz USA/Canada/Mexico 3346 100 volts, 50-60 hertz Japan 3511 240 volts, 50 hertz Australia 3537 IEC320 (with power cord: 3522) South Africa

9 V, 1 A

25039 IEC320, 90-250VAC input NOTE: Requires

appropriate IEC320 power cord for location

25040 120 volts, 60 hertz USA/Canada/Mexico

Environment Typical Operating Temperature*: 0° to 50°C (32°to 122°F )

Storage Temperature: -20°

to 85°C (-4° to 185°F)

Humidity 10-90%, non condensing Altitude 0-10,000 feet

Warranty Lifetime

DECLARATION OF CONFORMITY

Name of Mfg: Transition Networks

6475 City West Parkway, Minneapolis MN 55344 USA Model: SGETF10xx-100 Series Media Converters Part Number(s): SGETF1013-100, SGETF1014-100, SGETF1015-100,

SGETF1017-100

Regulation: EMC Directive 89/336/EEC

Purpose: To declare that the SGETF10xx-100 to which this declaration refers is

in conformity with the following standards.

EMC-CISPR 22: 1985 Class A&B; EN 55022: 1988 Class A&B; EN 50082-1:1992; EN 60950 A4:1997; IEC 801.2, IEC 801.3, and IEC 801.4; IEC 950

I, the undersigned, hereby declare that the equipment specified above conforms to the

above Directive(s) and Standard(s).

_ January 6, 2001_____

Stephen Anderson, Vice-President of Engineering Date

Full/Half-Duplex Advertisement UP=ON

Pause Advertisement UP=ON

LPT UP=ON

Not Used

+ 2 hidden pages