Tp-link TL-SG105, TL-SG108 User Manual

LED Explanation

Power

On: Power on

O: Power oﬀ

7106506416 REV2.2.0

Installation Guide

5/8-Port Gigabit Desktop Switch

TL-SG105/TL-SG108

Note: For simplicity, we will take TL-SG108 for example throughout this Guide.

Connection

Link/Act

1000M (Green)

On: Connected to a 1000Mbps device Flashing: Transmitting/receiving data

10M/100M (Yellow)

On: Connected to a 10/100Mbps device Flashing: Transmitting/receiving data

Internet

Power Adapter

Router

LAN PortWAN Port

TL-SG108

Ethernet Ports (1-8)

Frequently Asked Questions (FAQ) Specications

Q1. The Power LED is not lit.

The Power LED should be lit when the power system is working normally. If the Power LED is not lit, please check as follows:

A1:

Make sure the power adapter is connected to the switch with power

source properly.

A2:

Make sure the voltage of the power supply meets the requirements of

the input voltage of the switch.

A3:

Make sure the power source is ON.

Q2. Neither the 1000M LED nor the 10M/100M LED is lit when a device is connected to the corresponding port.

It is recommended that you check the following items:

A1:

Make sure that the cable connectors are rmly plugged into the switch

and the device.

A2:

Make sure the connected device is turned on and works normally.

A3:

The cable must be less than 100 meters long (328 feet).

For more information, please visit our website: http://www.tp-link.com

General Specications

Standard

Protocol

Data Transfer Rate

Network Media (Cable)

Interface

LED indicators

Advanced Features

Transfer Method

MAC Address Learning

Frame Filter Rate

Frame Forward Rate

IEEE802.3, IEEE802.3u, IEEE802.3ab,IEEE802.1p

CSMA/CD

Ethernet: 10Mbps (Half Duplex), 20Mbps (Full Duplex) Fast Ethernet: 100Mbps (Half Duplex), 200Mbps (Full Duplex) Gigabit Ethernet: 2000Mbps (Full Duplex)

10Base-T: UTP category 3, 4, 5 cable (maximum 100m) EIA/TIA-568 100

STP (maximum 100m)

100Base-TX: UTP category 5, 5e cable (maximum 100m)

EIA/TIA-568 100

STP (maximum 100m)

1000Base-T: UTP category 5e cable (maximum 100m)

EIA/TIA-568 100Ω STP (maximum 100m)

5/8 10/100/1000Mbps Auto-Negotiation RJ45 Ports

Power, 10/100M LED, 1000M LED

IGMP Snooping, QoS (802.1p/DSCP Priority)

Store-and-Forward

Automatically learning, automatically aging

10Base-T: 14881pps/Port 100Base-Tx: 148810pps/Port 1000Base-T: 1488095pps/Port

Environmental and Physical Specications

Operating Temperature

Storage Temperature

Operating Humidity

Storage Humidity

0˚C~40˚C (32˚F~104˚F)

-40˚C~70˚C (-40˚F~158˚F)

10%~90%RH non-condensing

5%~95%RH non-condensing

FCC STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning

the equipment oﬀ and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit diﬀerent from that to which the receiver is connected.

• Consult the dealer or an experienced radio/ TV technician for help. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1) This device may not cause harmful interference.

2) This device must accept any interference received, including interference that may cause undesired operation.

Any changes or modications not expressly approved by the party responsible for compliance could void the

user’s authority to operate the equipment.

BSMI Notice

安全諮詢及注意事項請使用原裝電源供應器或只能按照本產品注明的電源類型使用本產品。清潔本產品之前請先拔掉電源線。請勿使用液體、噴霧清潔劑或濕布進行清潔。注意防潮，請勿將水或其他液體潑灑到本產品上。插槽與開口供通風使用，以確保本產品的操作可靠並防止過熱，請勿堵塞或覆蓋開口。請勿將本產品置放於靠近熱源的地方。除非有正常的通風，否則不可放在密閉位置中。請不要私自打開機殼，不要嘗試自行維修本產品，請由授權的專業人士進行此項工作。

SAFETY NOTICES

Cautions

Do not use this product near water, for example, in a wet basement or near a swimming pool. Avoid using this product during an electrical storm. There may be a remote risk of electric shock from lightning.

Industry Canada Statement

CAN ICES-3 (B)/NMB-3(B)

CE Mark Warning

This is a class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.

Specications are subject to change without notice. is a registered trademark of TP-LINK TECHNOLOGIES CO.,

LTD. Other brands and product names are trademarks or registered trademarks of their respective holders.

No part of the specications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from TP-LINK TECHNOLOGIES CO., LTD. Copyright © 2016 TP-LINK TECHNOLOGIES CO., LTD. All rights reserved.

http://www.tp-link.com

Explanation of the symbols on the product label

DC voltage

RECYCLING This product bears the selective sorting symbol for Waste electrical and electronic equipment (WEEE). This means that this product must be handled pursuant to European directive 2012/19/EU in order to be recycled or dismantled to minimize its impact on the environment. User has the choice to give his product to a competent recycling organization or to the retailer when he buys a new electrical or electronic equipment