Quick Start Guide
Samsung
Bluetooth® Headset
WEP185
Get connected in 4 quick steps
Charge your headset
Put your headset in pairing mode Turn on Bluetooth on your phone and pair with headset
Test and use
Start here
Before using your headset
Thank you for purchasing the Samsung Bluetooth Mono Headset WEP185, we hope you will be delighted with its operation.
Take a moment before you get started to familiarize yourself with your new headset.
Multi-Function Adapter jack button
Earpiece
Volume control |
Indicator light |
|
|
buttons |
Microphone |
CheckCheck thethe accessoriesaccessories
MakeMake suresure youyou havehave thethe followingfollowing itemsitems withwith youryour headset:headset:
User’sUser’s Guide,Guide, CoverCover
NOTE:
The items supplied with your headset and the accessories at your Samsung dealer may vary, depending on you country or service provider.
•Bluetooth version: 2.0 (compatible with devices of
Bluetooth version 1.1 or higher)
•Supported Bluetooth profiles:
-Headset profile
-Hands-free profile
ChargeCharge youryour headsetheadset
Charge the headset's battery fully before using the headset for the first time.
1Plug the travel adapter into the jack on the headset.
2Plug the travel adapter into the electrical outlet.
•Charge the headset until the red light on the headset turns to blue.
•The headset will be fully charged in approximately 2 hours 30 minutes.
3 Remove the travel adapter from the headset.
NOTES:
•The headset cannot be used while charging.
•Use only a Samsung-approved charger or adapter.
Headquarters:
1301 East Lookout Drive Suite 150
Richardson, TX 75082
Internet Address: http://www.samsungmobileusa.com/ accessories
Customer Care Center:
1-888-987-4357
Guide No.: GH68-12655A
09/2006. Rev. 1.0
Put your headset in pairing mode
Before you can use your headset, you must pair it with your phone.
1Ensure that the headset is off (see Turn
headset on/off on the reverse side of this guide).
2Press and hold the Multi-Function button until the indicator light turns on in blue (approximately 8 seconds).
Turn on Bluetooth on your phone and pair with headset
1Set your Bluetooth phone to discover the headset by following your phone's guide.
Typically, the steps involve going to the Settings,
Connection, or Bluetooth menu on your phone and then selecting the option to discover Bluetooth devices.
Your phone will find the Samsung WEP185 headset. Your headset will be displayed as Samsung WEP180/185.
2Select your headset.
3When the phone asks if you want to pair with it, confirm by selecting Yes or OK.
4Enter the headset passkey or PIN, 0000.
Test and use
Your phone and headset are now paired and ready to make and receive calls. To confirm they are operating properly, make a call:
1Place the headset over your ear.
See Wearing the headset on the reverse side of this guide.
2On your phone, make a call to the number you want.
3If your phone and headset are successfully paired, you will hear ringing on the headset.
After you have successfully paired your phone and headset, you do not need to repeat these initial setup steps each time you use the headset.
Using your WEP185
See Features and Functions Guide on the reverse side of this guide
for information on using your WEP185.