Operation Manual
Split Type Wall Mounted Air Conditioner
Models: RINV25RC / RINV34RC / RIN51RC / RINV70RC
ON/OFF
COOL |
HEAT |
SWING |
|
|
SWING |
COOL |
RUN |
|
|
|
C |
SPEED |
TURBO |
SWING |
|
|
LRSWING |
FAN
This appliance shall be installed in accordance with:
•Manufacturer’s Installation Instructions
•Current AS/NZS 3000
•Local Regulations and Municipal Building Codes including local OH&S requirements This appliance must be installed, maintained and removed by an Authorised Person.
For continued safety of this appliance it must be installed and maintained in accordance with the manufacturers instructions.
TABLE OF CONTENTS
Warnings and Important Information |
3 |
Air Conditioner Basics |
5 |
Appliance Components 5
Remote Control Batteries 5
Remote Control Cradle 5
Controller Operating Basics 5
Remote Control Layout 6
Basic Operation |
7 |
On 7 Off 7 Cooling 7 Heating 7 Fan Speed 7 Adjusting Vertical air flow 8 Adjusting Horizontal air flow 8
Advanced Operation |
9 |
Auto Mode 9 Dry (Dehumidifying) Mode 9 Fan Only Mode 9 Turbo 10 Quiet 10 Health (Wi-Fi) 10 Sleep Mode 10 Delay On Timer 11 Delay Off Timer 11 Cancelling ON/OFF timers 11 Room Temperature Display 11 Large Temperature Display 12 Auto Fresh 12 Spot Swing 12 Economy (cooling Only) 12 Cleaning Operation 13 Operating The Air Conditioner Without The Remote Control 13 Power Interruption Automatic Restart 13
Care & Maintenance |
14 |
General Maintenance 14 Cleaning the air filter 14 Save A Service Call 15 When to Call for Service 15
Warranty |
16 |
Installation Record |
19 |
Installer Details |
19 |
System Details |
19 |
Contacts |
20 |
Rinnai |
2 |
Split AC OM |
WARNINGS AND IMPORTANT INFORMATION
IMPORTANT
WARNING
READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE.
Always comply with the following precautions to avoid dangerous situations and to ensure optimum performance.
Failure to carefully read and follow all instructions in this manual can result in equipment malfunction, property damage, personal injury and/or death.
WARNINGS: WHEN IGNORED, CAN RESULT IN SERIOUS INJURY OR DEATH. CAUTIONS: WHEN IGNORED, CAN RESULT IN MINOR INJURY OR PRODUCT DAMAGE.
REGULATORY / INSTALLATION
This appliance shall be installed in accordance with: Manufacturer’s Installation Instructions.
Current AS/NZS 3000.
Local Regulations and Municipal Building Codes including local OH&S requirements. This appliance must be installed, maintained and removed by an Authorised Person.
For continued safety of this appliance it must be installed and maintained in accordance with the manufacturers instructions.
This appliance uses R410A refrigerant.
This appliance is heavy, use 2 people or mechanical lifting device. Improper lifting may result in serious injury.
Take care when opening or unpacking this appliance. Failure to do so may result in serious injury or product failure.
DO NOT modify the electrical wiring of this appliance. If the control power wiring is damaged or deteriorated then it must be replaced by an authorized person. Failure to do so may result in electric shock, fire, serious injury or product failure.
DO NOT install the air conditioner on an unstable or non level surface or where there may be a danger of it falling. It may result in death, serious injury, or product failure.
DO NOT install the outdoor unit where noise may cause nuisance.
DO NOT install the outdoor unit where it will be exposed to sea wind (salt spray) as this will reduce durability.
OPERATION RANGE LIMITATIONS
The table below indicates the temperature ranges the air conditioner can be operated within.
|
|
MINIMUM |
MAXIMUM |
|
MODE |
TEMPERATURE SOURCE |
OPERATION |
OPERATION |
|
|
|
TEMPERATURE |
TEMPERATURE |
|
|
|
|
|
|
Cooling / Heating |
Adjustable inside temperature |
16°C |
32°C |
|
Ambient outside temperature |
-12°C |
47°C |
||
|
Rinnai |
3 |
Split AC OM |
WARNINGS AND IMPORTANT INFORMATION
OPERATION
WARNINGC UTION DO NOT let the air conditioner run for extended periods when the humidity is very high or when doors or windows are left open. As this may result in an excessive operational loading and lead to product failure.
DO NOT cover or place articles on any part of this appliance.
DO NOT touch, operate or clean the air conditioner with wet hands. It may result in electric shock or product failure.
DO NOT insert hands or other objects through the air inlet or outlet while the appliance. It may result in electric shock or product failure.
DO NOT place a heater or other heating appliances near this appliance, always ensure sufficient ventilation when using this appliance and a heating appliance at the same time. Failure to do so may result in product miss-operation.
Turn main power off before cleaning. Failure to do so may result in fire, electric shock, or product failure.
DO NOT use solvents, abrasives or harsh detergent to clean any part or surface of this appliance or spray water or allow liquids to enter the indoor unit. The enclosure of the appliance and remote control can be cleaned using a soft, damp cloth and a mild detergent.
NEVER touch the metal parts of the air conditioner when you remove the air filter. It may result in electric shock or product failure.
DO NOT leave flammable materials near the appliance. It may result in explosion or fire.
If there is excessive noise, smell or smoke coming from the appliance, turn the appliance OFF, isolate the power supply and contact a service agent.
DO NOT operate the appliance if it has been submerged into water due to flooding, contact a service agent. Failure to do so may result in electric shock, fire, serious injury, or product failure.
This appliance is NOT intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
The air conditioning system is designed to achieve consumer comfort. It is not designed for commercial applications required a controlled atmosphere (i.e. computer rooms, food preservation, etc.)
DO NOT block the inlet or outlet of air flow. It may result product failure.
DO NOT drink the condensate water drained from the appliance. This condensate is not potable and may present a health risk if consumed.
DO NOT expose people, animals or plants directly to the cold or hot discharge of the appliance. It may result in serious injury.
DO NOT mix the batteries for the remote control with other types of batteries or mix new batteries with used batteries. Failure to do so may result in product failure. STOP using the remote control if there is a battery fluid leak.
Rinnai |
4 |
Split AC OM |
AIR CONDITIONER BASICS
APPLIANCE COMPONENTS
1.Indoor unit air inlet
2.Filter (located behind front access panel)
3.Manual ON/OFF (Auto) override button (located behind front access panel)
4.Indoor unit air outlet (with louvres and vanes for setting air flow direction)
5.Remote control
6.Signalreceiverwindowandsettemperature display (the display is built into the front access panel)
7.Refrigerant pipes, electrical cable(s) (covered with binding tape)
8.Condensate drain hose (covered with binding tape)
9.Refrigerant entry (for service and installer use only)
10.Outdoor unit air inlet (on rear & left side of unit)
11.Outdoor unit air discharge and protective grille (on front of unit)
2 |
1 |
|
6 |
|
|
|
3 |
|
4 |
|
COOL |
|
|
C |
|
|
|
5 |
|
INDOOR UNIT |
SWING |
SWINGHEAT |
|
OUTDOOR UNIT 10 |
|
7 |
|
11 |
|
|
|
10 |
|
|
8 |
|
|
|
|
|
|
|
9 |
REMOTE CONTROL BATTERIES
Insert batteries before using the remote control. The battery type used is AAA (1.5 V).
1.Remove the battery cover at the rear of the remote control.
2.Insert the new batteries and make sure that the + and - terminals of the batteries are installed correctly.
3.Reattach the battery cover.
If the LCD screen of the remote control starts to fade or fails to transmit, replace the batteries.
NOTE
REMOTE CONTROL CRADLE
For convenience a slide-in cradle is provided for fixing the remote control to a wall.
To Install:
IMPORTANT Choose a safe and easily-accessible place. DO NOT mount the cradle in direct sunlight as this may damage the controller.
Fix the cradle to the wall using the holes provided using 2 screws.
CONTROLLER OPERATING BASICS
Point the remote control towards the signal receiver at the bottom of the air conditioner to operate it.
The remote control may operate other electronic devices if pointed towards them. Make sure to point the remote control towards the signal receiver of the air conditioner.
NOTE
For proper operation, use a soft cloth to clean the signal transmitter LED and the receiver window.
Rinnai |
5 |
Split AC OM |
AIR CONDITIONER BASICS
REMOTE CONTROL LAYOUT
The external buttons are for basic operations, the buttons located behind the door are for advanced operations.
1.ON / OFF button
Turns the power on/off.
2.FAN speed button
Adjusts the fan speed: AUTO / LOW /MEDIUM / HIGH.
3.Temperature adjustment buttons
Adjusts room temperature when cooling and heating.
4.COOL
One touch cooling operation.
5.HEAT
One touch heating operation.
6.SWING↕ button (vertical)
Adjusts the air flow direction vertically.
7.SWING↔ button (horizontal)
Adjusts the air flow direction horizontally.
8.Operation MODE selection button
Selects the operation mode: AUTO / COOLING / DRY
(dehumidifying) / HEATING / FAN (fan only).
9.TURBO cooling / heating button
Warms or cools rooms at the fastest rate.
10.HEALTH button
Used to access Wi-Fi operation.
11.QUIET button
Sets appliance operation to lowest noise output level.
12.SLEEP button
Sets the sleep mode auto operation.
13.TIMER button
Sets the count down timer to turn the power ON / OFF.
1
4
6
20
AUTO RUN ROOM |
|
||
COOL |
C |
|
|
DRY |
|
21 |
|
HEAT AUTO |
SILE |
||
FAN SPEED |
|
||
HEALTH |
SWING |
POWERCONLRSWING |
|
DISPLAY SLEEP |
iFEEL |
|
|
iCLEAN |
Anti-F |
|
|
H |
|
||
LOCK ELE.H |
|
||
ECO PIR |
ON OFF |
|
|
ON/OFF |
FAN |
2 |
|
|
|
|
3 |
COOL |
HEAT |
5 |
|
SWING |
SWING |
7 |
|
|
|
|
|
Basic
Operation
Buttons
14.ROOM°C Temperature display button
Displays the temperatures: ROOM / SET.
15.DISPLAY button
Turns indoor temperature display ON / OFF.
16.FRESH button
Keeps the head unit free of excess moisture by running a 3 min cycle every time the unit is turned off.
17.CLEAN button
End of season cleaning process to dry the inside of the indoor unit or when the appliance is not going to be used for an extended period of time.
18.SPOT SWING button
Sets a fixed direction for air flow horizontally.
19.ECO button
Sets appliance to the most efficient operation.
20.Wireless Transmitter LED
21.LCD screen
Displays settings and operation modes.
22.Blank buttons
Not used.
8 |
1 |
9 |
11 |
3 |
13 |
15 |
17 |
22 |
22 |
22 |
LOCK ELE.H |
H |
ECO PIR |
ON OFF |
ON/OFF |
MODE |
FAN |
2 |
|
TURBO |
|
HEALTH |
10 |
|
|
12 |
|||
QUIET |
|
SLEEP |
||
|
|
|||
TIMER |
|
ROOM°C |
14 |
|
DISPLAY |
CLEAN |
FRESH |
16 |
|
18 |
||||
|
ECO |
SPOT |
||
|
SWING |
|
19
Advanced
Operation
Buttons
Rinnai |
6 |
Split AC OM |
Loading...