InstructionSheet
InstructionSheet
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information and instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials, and proper lamping. Do not install
in areas subject to combustible vapors or gases. Before wiring to power supply and during servicing or relamping, turn off power at fuse or
circuit breaker. All installation servicing or relamping must be performed by qualified service personnel. Product must
be grounded to avoid potential electric shock or other potential hazard. Product must be mounted in locations and
at heights and in a manner consistent with its intended use, and in compliance with the National Electrical Code
and local codes. The use of accessory equipment not recommended by the manufacturer or installed contrary to instructions may cause
an unsafe condition. Do not block light emanating from product in whole or part, as this may cause an unsafe condition. Do not allow items
such as drapes, curtains, screens or the like to come into contact with the product or to block light from the product, as this may cause an
unsafe condition.
WARNING- This product contains chemicals known to the State of California to cause cancer, birth defects and/or
other reproductive harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this
product.
LBC6P Pendant Mount Installation Instructions
CAUTION: TO REDUCE THE RISK OF ELECTRICAL SHOCK,
MAKE CERTAIN THAT THE POWER IS OFF BEFORE
INSTALLING OR SERVICING THIS FIXTURE
1. Insert socket wires through stem and
screw stem into adapter on top of the
fixture, secure with set screw.
2. Insert socket wires through canopy/
swivel assembly, screw stem into
assembly and secure with set screw.
3. Rotate and slide canopy cover from
mounting plate.
4. Align appropriate keyhole slots in
mounting plate with J-Box screws and
rotate to lock in place.
5. Connect black and white fixture wires
to the respective black and white supply
wires with wire nuts. Attach fixture and
supply ground wires to ground screw on
mounting plate.
6. Re-attach the canopy
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 93041499
CANOPY/SWIVEL
SET SCREW
ASSEMBLY
STEM
www.prescolite.com • Prescolite TollFree Technical Support 1.888.PRS.4TEC • Hours: 8am - 5pm ET
FIXTURE
ADAPTER
SET SCREW
CAUTION: DO NOT ATTEMPT TO MODIFY OR REWIRE FACTORY-INSTALLED WIRING ON THE FIXTURE. SAFETY AND PROPER
OPERATION OF THE FIXTURE DEPEND ON THE INTEGRITY OF THE WIRING.
KEEP THESE INSTALLATION INSTRUCTIONS
701 Millennium Boulevard • Greenville, SC 29607
With representatives offices in principal cities throughout North America.
Copyright 2012, 4/12/12 revision, All Rights Reserved - Printed in U.S.A.
Loading...