OfficeRightTMDesktop Letter Folder DF100
SV40207 First Edition, May 2003 © 2003 Pitney Bowes Inc.
All rights reserved. This book may not be reproduced in whole or in part in any fashion or stored in a retrieval system of any type or transmitted by any means, electronically or mechanically, without the express written permission of Pitney Bowes Inc.
We have made every reasonable effort to assure the accuracy and usefulness of this manual, however, we cannot assume responsibility for errors or omissions or liability for the misuse or misapplication of our products.
OfficeRight is a registered trademark and PB Supply Line is a service mark of Pitney Bowes Inc.
WARNING: Never connect power to this product until you are ready to use the letter folder. The AC outlet used for this machine must be nearby and must not be blocked. This machine contains moving parts that can catch hair, loose clothing or jewelry. During operation and maintenance, keep hair, loose clothing and jewelry clear of moving parts. Disconnect the power supply from the wall outlet before attempting any service to the unit, and before removing the cover for any reason.
Specifications
Operation: Manual feed, automatic on/off, 1800 letter folds per hour Paper Sizes: Adjustable for two standard paper sizes:
•8 1/2" x 11" to fit a #10 envelope
•ISO A4 paper (210 x 297mm) to fit a DL envelope (Europe) Capacity: 1-3 sheets of 16-24# bond paper. Sheets may be stapled. Power: 1.2 Amp 24 Volt wall pack power supply
Size: 12 3/4" W x 6" H x 5 1/2"D (326mm W x 153mmH x 140mm D) Weight: 7.5 lbs. (3.4 kg)
Page 2
OfficeRightTMDesktop Letter Folder DF100
Normal Operation
1.Insert the power connector into the receptacle on the right hand side of the paper folder (see figure below). Plug the other end of the power connector into an appropriate wall outlet. NOTE: The paper folder does not have an ON-OFF switch, so your folder is active immediately after the power connector is plugged in.
Connect to
Wall Outlet
Power Connector
Goes Here
2.Insert up to three sheets of paper approximately 1 1/2" into the rear slot. Hold paper so that it lies squarely in the nip (pinch point) of the rollers underneath. There will be a brief time delay, then the folder will automatically pull the paper in. Once the folding starts, the paper should be released. NOTE: For accurate folds, hold your document very lightly at the top center of the sheets, as shown below. This will allow the paper to square itself on the folding rollers.
3. Remove the folded paper from the front slot.
Page 3
Loading...