Philips ESXMIM-F2, ESXMIM User Manual
PhotoFrame Firmware Upgrade Instructions
Applicable models 8FF3WMI
Firmware version 1.01
Release date September 19, 2008
Release notes
Important notice before updating
The firmware upgrade process will remove all photos currently stored on PhotoFrame.
!
Please make sure all photos on PhotoFrame are properly backed up before updating.
Please follow the steps below to upgrade the PhotoFrame firmware.
!
1 Format SD (Secure Digital) card
2 Copy all files from the ‘Firmware’ folder into the root folder of the SD card
(The root folder is the ‘highest’ folder in hierarchy, for example F:\)
3 Make sure PhotoFrame is powered Off
4 Insert SD into PhotoFrame with the new firmware into the PhotoFrame
5 Push the Power button to power on the PhotoFrame
6 The firmware upgrade will start automatically
Warning: Upgrade takes about 1 minute.
During the upgrade do not disconnect power, remove the memory or make new
!
connections. Otherwise this may harm your PhotoFrame.
7 When "Please reboot system!" shows, firmware upgrade has finished
8 Remove the memory from the PhotoFrame
!
9 Power Off the PhotoFrame and Power On afterwards by pushing the Power button
10 The upgrade has completed
You can check the new firmware version via Setup → Status →Firmware.
Loading...