OLYMPUS C-200 Zoom TECHNICAL INFORMATION TID C200Z E003

TECHNICAL INFORMATION
y
NO. TID-C200Z-E003
DATE January.25.2002
Revised by OE/CPI-TSD
SUBJECT: Countermeasure for “Arrow Key doesn’t work”
Product Name :
Contents :
New arrow key(BUTTON MODE A) is supplied as countermeasure for “Arrow key doesn’t work”.
Countermeasure :
Replace the arrow key with new arrow key when customer complains about this problem.
Spare Parts :
1. VC179100 (BUTTON MODE A) is supplied as single parts newly.
2. VC160900 (COMPL,CABI BACK) is “Running Change” (Parts number is not changed) New (modified) one : A “N” stamp is printed on new one. Please refer to Fig1. Old (un-modified) one : No stamp
1/2
Fig.1
If it is Old (un-modified) VC160900, Replace the arrow key with new one(VC179100) and apply glue (SuperX) to these positon to fix new one(VC179100). Please refer to next page.
If it is New(modified) VC160900, “N”stamp is printed in this position and it is not necessar
to replace the arrow key.
OLYMPUS OPTICAL CO.,LTD TOKYO
Removal and installation of the arrow key
)
2/2
Fig.2
Fig.3
Fig.4
1. Remove the melted plastic carefully so that the boss can remain.
2. Remove the arrow key and install new arrow key(VC179100).
3. Apply glue(SuperX) to area A.
Please refer to Fig3, Fig4 and Fig5.
OK
The height of glue is the same as surface of arrow key. The glue must not be protruded from area A.
NG (The glue amount is too less.)
Fig.5
The glue amount is too less and was protruded from area A. Note! : The glue protruded from area A must be wiped off.
NG (The glue amount is too much.)
The glue amount is too much and was protruded from area A. Note! : The glue protruded from area A must be wiped off.
If the glue is taller than the surface of arrow key after dried up, the glue presses down the circuit board. (especially the boss of the upper left side
If the glue is protruded from area A, the glue sticks to the circuit board. (especially the boss of the bottom right side)
OLYMPUS OPTICAL CO.,LTD TOKYO
Loading...