B. DISASSEMBLY AND ASSEMBLY PROCEDURE C-2/D-230
B. DISASSEMBLY AND ASSEMBLY
PROCEDURE
[1] REMOVAL OF CABINET BACK, CABINET FRONT AND TB1 BOARD ................B-2
[2] REMOVAL OF LCD AND CA2 BOARD ..................................................................B-3
[3] REMOVAL OF CA1 BOARD AND LENS ASSEMBLY ...........................................B-4
[4] BOARD LOCATION ................................................................................................B-4
B-1 Ver.1
B. DISASSEMBLY AND ASSEMBLY PROCEDURE C-2/D-230
[1] REMOVAL OF CABINET BACK, CABINET FRONT AND TB1 BOARD
Disassembly perform as follows and assembly perform by reversing the disassembly steps.
Be sure to discharge the main capacitor, then continue to disassembling.
! Beware of electric shock
Danger of electric shock.
Use a discharging tool to remove
the electrical charge before working.
1. Open the cover card.
2. Two screws 1.7 x 6.0
3. Five screws 1.7 x 4.5
4. Cabinet back
5. Cover jack
6. Cover battery
7. Stand
8. Discharge both edge of C5412
9. Screw 1.7 x 3.5
10. Cabinet front
11. Screw 1.7 x 3.5
12. TB1 board
13. Remove the solder
4
3
6
12
Gr
Br
11
1
B
W
Y
13
9
3
5
8.Discharge both
2
7
10
edge of C5412.
B-2
Ver. 1
B. DISASSEMBLY AND ASSEMBLY PROCEDUREC-2/D-230
[2] REMOVAL OF LCD AND CA2 BOARD
1. Connector
2. FPC
3. LCD
4. Holder flash
Forming for read wire
Silicone
bond
BK
Silicone
bond
Silicone
bond
Gr
RD
4
Gr
BK
RD
3
T5402
1
2
Ver. 1
5. Four screws 1.7 x 3.5
6. FPC
7. Connector
8. Three screws 1.7 x 3.5
9. Holder monitor
5
JW502
BK
B-3
JW501
RD
RD
8
BK
7
6
9
B. DISASSEMBLY AND ASSEMBLY PROCEDURE C-2/D-230
[3] REMOVAL OF CA1 BOARD AND LENS ASSEMBLY
1. Two screws 2 x 5
2. Screws 1.7 x 2.5
3. CA1 board
[4] BOARD LOCATION
Lens
3
2
1
CCD
TB1 board
CA2 board
CA1 board
B-4
Ver. 1
Loading...