This easy-to-use Quick Reference Guide is intended to help you more fully appreciate
some of the unique features and functions of your new vehicle. However, it is not intended
to replace your Owner’s Manual. The Owner’s Manual contains more detailed information
to help you better understand the important safety warnings, features, operation, and
maintenance of your vehicle.
REMOTE KEYLESS ENTRY SYSTEM
(if so equipped)
LOCK DOORS
Press the
button to lock all doors.
UNLOCK DOORS
Press the
button once to unlock the driver’s
door only. Press the button again within 5
seconds to unlock all doors.
USING THE PANIC ALARM
Press and hold the
button for longer than 0.5 seconds. The panic alarm will
sound and the headlights will stay on for 25 seconds. The panic alarm stops
when it has run for 25 seconds, or when any button is pressed on the keyfob.
SILENCING THE HORN BEEP FEATURE
■ To deactivate – Press and hold the
■ To activate – Press and hold the
and
and
buttons for at least 2 seconds.
buttons for at least 2 seconds.
INTELLIGENT KEY SYSTEM (if so equipped)
The Intelligent Key System allows you to lock or unlock
your vehicle, open your trunk or rear hatch, and start the
engine.
NOTE: It is important to make sure the Intelligent Key is
with you (that is, in your pocket or purse).
■ The operating range of the door and hatchback/trunk
lock/unlock function is approximately 31 in (0.8 m).
■ Locking the vehicle - Push any door handle request
switch
once.
01
■ Unlocking the vehicle - Push any door handle request
switch
Push the door handle request switch
once. The corresponding door will unlock.
01
01
again within
1 minute; all other doors will unlock.
01
OPENING THE RE AR HATCH (if so equipped)
■ Push the rear hatch door request switch
03
■ Push the release switch
under the rear hatch
02
.
handle.
■ Pull up and out on the handle to open rear hatch.
OPENING THE TRUNK (if so equipped)
■ Push the trunk request switch
■ Push the release switch
02
.
03
under the trunk handle.
■ Pull up and out on the handle to open the trunk.
2
02
03
02
03
WINDSHIELD WIPER/WASHER SWITCH
■ The ignition switch must be in the ON position
to activate the windshield wipers.
1
B
■ Move the lever to the following positions to
operate the windshield wipers:
1
A
Intermittent (INT) – Front wipers operate
intermittently and can be further adjusted
1
B
by twisting the time control ring
02
Low Speed (LO) – Continuous low-speed
.
operation of front wipers.
03
High Speed (HI) – Continuous high-speed
operation of front wipers.
04
Mist (MIST) – Lift the lever up for one sweep of the front wipers.
05
Rear Wipers (REAR) – Twist the end section to operate the first (INT) or second
(ON) speed settings for the rear wipers.
■ Pull the lever toward you to activate front washer fluid and several sweeps of
the wipers.
HEADLIGHT AND TURN SIGNAL CONTROL
HEADLIGHT CONTROL SWITCH
■ Turn the headlight control switch
01
to the
02
01
position to turn on the front parking, tail, license plate and
instrument panel lights.
■ Turn the headlight control switch
01
to the
position to
turn on the headlights. All other lights remain on.
04
05
1
A
02
03
FOG LIGHT OPERATION (if so equipped)
NOTE: The headlights must be on and the low beams selected for the fog lights to operate.
■ Turn the switch (inside collar)
■ Turn the switch (inside collar)
to the
02
to the OFF position to turn off the fog lights.
position to turn on the fog lights.
02
TURN SIGNAL SWITCH
■ Move the headlight control switch up or down
signal a turning direction. When the turn is completed,
A
to
A
B
the turn signals cancel automatically.
■ To signal a lane change, move the headlight control
switch up or down
to the point where the indicator
B
B
A
light begins to flash, but the headlight control switch
does not latch.
HIGH BEAM
■ Push the headlight control switch forward
select the high beam function. The blue
C
to
indicator light
C
illuminates. Pull the headlight switch back to the original
position to select the low beam. The blue
indicator
D
light goes off.
D
■ Pull and release the headlight control switch
to flash the headlight high beams on
and off.
3
STEERING WHEEL SWITCHES FOR AUDIO
CONTROL (if so equipped)
■ Press the SOURCE button to turn the radio
system on.
■ To choose Preset A, B, C, CD or XM
®
(if so equipped)
press SOURCE repeatedly.
■ The tuning up or down
perform the following:
• Push the
switch for less than 1.5 seconds to change to a preset station.
• Push and hold the
broadcasting radio station.
• Push the
change tracks on the CD.
switch while playing a CD (if so equipped) for less than 1.5 seconds to
switch can be used to
switch for more than 1.5 seconds to seek the next or previous
• If the vehicle is equipped with a CD changer, push and hold for more than 1.5
seconds to change between CDs.
■ Push the + or – control switch to increase or decrease the volume.
CRUISE CONTROL (if so equipped)
■ To activate the cruise control, push the ON/OFF
switch. The indicator light in the instrument panel will
illuminate.
■ To set cruising speed, accelerate the vehicle to the
desired speed, push the COAST/SET switch and
release it. The SET indicator light in the instrument
panel will illuminate.
■ To reset at a faster cruising speed, push and hold the ACCEL/RES switch. When the
vehicle reaches the speed you desire, release the switch.
■ To reset at a slower cruising speed, push and hold the COAST/SET switch. Release
the switch when the vehicle slows to the desired speed.
■ To cancel cruise control, push the CANCEL switch or tap the brake pedal. The SET
indicator light in the instrument panel will go out.
■ To resume a preset speed, push and release the ACCEL/RES switch. The vehicle
returns to the last set cruising speed when the vehicle speed is over 24 MPH (38
km/h).
■ To turn off cruise control, push the ON/OFF switch. Both the CRUISE indicator light
and the SET indicator light in the instrument panel will go out.
4
Loading...
+ 13 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.