Nec XEN TOPAZ user manual

Conferencing

Establishing a Conference Call

Repeat for additional parties

FLASH

8 2 6

(Talking)

 You can repeat this operation to add additional parties. You may

be able to have up to 8 parties in total (including your extension).

Extension Number

? ? ?

Trunk Code Telephone

0

? ?

(Talk)

FLASH

<press twice>

Intelligent Hybrid System

Nothing contained in this manual shall be deemed to be, and this manual does not constitute, a warranty of, or representation
with respect to, any of the equipment covered. This manual is subject to change without notice and NEC Business Solutions
Ltd has no obligation to provide any updates or corrections to this manual. Further, NEC Business Solutions Ltd also reserves
the right, without prior notice, to make changes in equipment design or components as it deems appropriate. No representation
is made that this manual is complete or accurate in all respects and NEC Business Solutions Ltd shall not be liable for any
errors or omissions. In no event shall NEC Business Solutions Ltd be liable for any incidental or consequential damages in
connection with the use of this manual. This document contains proprietary information that is protected by copyright. All rights
are reserved. No part of this document may be photocopied or reproduced without prior written consent of NEC Business
Solutions Ltd.

NEC Business Solutions Ltd
633-647 Springvale Road,
Mulgrave VIC 3170

Copyright © 2004 by NEC Business Solutions Ltd

All Rights Reserved.

October 2004

Single Line Telephone

User Guide

Issue 1.2

Before using Your Telephone…

Thank you for purchasing the NEC “Xen Topaz” system.

Due to the flexibility built into the system, your Dialling Codes and Feature Capacities may differ from those
in this guide. Check with your Supplier / System Administrator and make a note of any differences.

Using Your Telephone

NEC AT-21 Single Line Telephone is displayed here. This User Guide describes general analogue Single Line
Telephone (SLT) procedures. Refer to the User Guide included with to your specific SLT for details on
additional key functions.

Handset

Dial Keys

Message Lamp

Ring Key

Redial Key

Flash Key

Forwarding Calls / Do Not Disturb

Do Not Disturb (DND)

DND : Trunk Incoming Call

8 74

 When you set DND, the Internal Dial Tone pattern changes.

Call Forwarding / Follow Me

CFW Condition

8 ? ? ?

8 8

Busy / No Answer

Follow Me

3

Immediate

4 0

62
7

1
2
3
4
0

?

No Answer

Dual Ring

Cancel

DND : Intercom Incoming Call

DND : Trunk & Intercom Incoming Call

DND : Transferred (CFW) Call

DND : Cancel

Extension Number

CFW Type

?

FWD All Calls

2

FWD Outside Calls only

3

FWD Intercom Calls only

4

Volume Control Keys

 When you set a Call Forward, the Internal Dial Tone pattern changes.

Call Forward Off-Premise

7 31

Telephone Number

6

? ? ?0

To Cancel

 When you set a Call Forward, the DND/CONF Key’s lamp flashes and the Internal Dial Tone pattern

changes.

1 6