Side by Side
Installation
MRB 2400 / MRB 3000 / MRB 3600
MF 1851 / MF 2451
7083 044-00
Parts list of SBS Installation Kit
Image Article num-
ber
6943 001-00 Heating blanket
9022 776-00 Front connecting plate
Name of the item
9022 778-00 Rear connecting plates
9022 777-00 Top connecting plate
2
Image Article number Name of the item
7641 033-00 Sealing strip
4098 066-01 Screws 6 x 25
4084 005-01 Screws M4 x 13
Other parts used in this installation manual are supplied with the appliance, not with the SBS Kit.
3
Side by Side (SBS) Installation
WARNING !
Risk of fire or damage.
The accessory is intended for use only
with an appliance that is marked to indicate
such use.
This kit may only be installed with models
MRB 2400, MRB 3000, MRB 3600
MF 1850, MF 2450
The Side by Side installation should only be done by
a trained expert. We recommend this procedure be
done by two people.
WARNING !
Electrocution hazard.
The refrigerator must be disconnected
from the source of electrical supply before
attempting the installation.
1. Remove the anti-tipping brackets from both appliances. The screws are no longer needed.
Adjustment of the anti-tipping bracket for
use in a 25" deep recess
Both base parts of the bracket must be
adjusted for use in a recess with a
depth of 25".
Anti-Tipping Device
The anti-tipping device is mounted on the back wall in
the recess at the finished installation height. After the
appliance is in the recess and raised in height, the hook
of the bracket will connect with the appliance top and
prevent tipping.
WARNING !
• Theanti-tippingbracketmustbemountedto
prevent the appliance from tipping when the
fully stocked door is opened.
- Loosen the screws.
- Move the base part back
or forth.
- Tighten the screws.
Adjustment for 5/8"
door panels
If the recess is deeper than 25", a spacer must be mounted between bracket and wall.
Adjustment for 3/4" door
panels
• Besurethatthereisnoplumbingor
electrical wiring located in this area which
screws or drills could damage.
4