WASHING
MACHINE
Please read this manual carefully before operating your washing machine and retain it for future reference.
FH0H3NDNL(0~9)2
FH0G7NDNL(0~9)2
FH2G7NDNL(0~9)2
FH0G7WDNL(0~9)2 MFL67584563 FH0G6WDNL(0~9)2
FH2G6HDNL(0~9)2
P/NO : MFL67584563
Copyright © 2017 LG Electronics. All rights reserved.
Rev. No.: 00_03/03/2017
Drawer
(For detergent and fabric softener)
Door
Lower cover
Adjustable leg
Power Plug
If the supply cord is damaged, it must be replaced by the
manufacturer or its service agents or a similarly qualified person in order to avoid a hazard.
Control Panel
Drum
Drain Pump Filter
Drain Plug
Lower Cover Cap
6.0kg : [FH0H3NDNL(0~9)2/FH0G7NDNL(0~9)2/FH2G7NDNL(0~9)2] 6.5kg : [FH0G7WDNL(0~9)2/FH0G6WDNL(0~9)2]
7.0kg : [FH2G6HDNL(0~9)2]
No Spin/400/600/800/1000 : [FH0H3NDNL(0~9)2/FH0G7NDNL(0~9)2/
FH0G7WDNL(0~9)2/FH0G6WDNL(0~9)2]
No Spin/400/800/1000/1200 : [FH2G7NDNL(0~9)2/FH2G6HDNL(0~9)2]
100-1000kPa (1.0-10kgf/cm2 )
carpeted floor.
subjected
in
caused
Unpacking
Cut the straps and open the upper flaps of Packing box & take out the Anti Rat Cover. While taking out the Machine from packing, please take due care in removing packing support given at centre of the base packing.
Anti Rat Cover is placed below the upper flaps of the Packing box.
Anti Rat Cover installation
Packing Support
Accessories for fixing Anti Rat Cover.
1.Take out the poly bag (containing Screws/Washers).
2.Tilt the machine sideways.
3.Bend & insert the flaps of Anti Rat Cover into the bottom side of machine.
4.Assemble the Anti Rat Cover on the bottom side of the machine by using Screws & Washers.
Machine.
5
adjustable legs
It is advisable to avoid, the usage of trolley & the movement of Washing Machine after installation. As it may disturb the levelling of washer, which can create excessive noise & vibration.
6
Centre
(1.0~10kgf/cm²)
Part can be different according to different models.
Two rubber seals are provided with inlet hose connectors.
These are used to prevent water leakage.
Make sure the connection to tap is sufficiently tight.
Check rubber seals in inlet hose connectors.
Screw the hose connector onto water supply tap.
Hose
Connector
Rubber seal
Break
PE Bags
getting wet
getting wet
/leakage