LG FFH-2000AX User Manual

? Outdoor Antenna Grounding If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is grounded so as to provide some protection against voltage surges and built-up static charges.

?Article 810 of the National Electrical Code, ANSI/NFPA 70 proviedes information with regard to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna

discharge unit, size of grounding conductors, location of antenna discharge unit, connection to grounding electrodes, and requirements for the grounding electrode.

?Power Lines An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can

	fall into such power lines or circuits. When installing
	an outside antenna system, extreme care should be
	taken not to touch such power lines or circuits as
	contact with them might be fatal.
?	Overloading Do not overload wall outlets, extension
	cords, or integral convenience receptacles, as this
	can result in a risk of fire or electric shock.
?	Object and Liquid Entry Never push objects of any
	kind into this product through openings as they may
	touch dangerous voltage points or short-out parts that
	could result in a fire or electric shock. Never spill
	liquid of any kind on the product.
?	Servicing Do not attempt to service this product
	yourself as opening or removing covers may expose
	you to dangerous voltage or other hazards. Refer all
	servicing to qualified service personnel.
?	Damage Requiring Service Unplug this product from
	the wall outlet and refer servicing to qualified service
	personnel under the following conditions:

a)When the power-supply cord or plug is damaged.

b)If liquid has been spilled, or objects have fallen into the product.

c)If the product has been exposed to rain or water.

d)If the product does not operate normally by

following the operating instructions. Adjust only those controls that are covered by the operating instructions as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation.

e)If the product has been dropped or damaged in any way.

f)When the product exhibits a distinct change in performance, this indicates a need for service.

?Replacement Parts When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or

	have the same characteristics as the original parts.
	Unauthorized substitutions may result in fire, electric
	shock, or other hazards.
?	Safety Check Upon completion of any service or
	repairs to this product, ask the service technician to
	perform safety checks to determine that the product is
	in proper operating condition.
?	Wall or Ceiling Mounting The product should be
	mounted to a wall or ceiling only as recommended by
	the manufacturer.
?	Heat The product should be situated away from heat
	sources such as radiators, heat registers, stoves, or
	other products (including amplifiers) that produce
	heat.

3