Kargo Master NV200 User Manual

40933 Parts List

Front Bow Assy. (1)

Rear Bow Assy. (1)

Rail Mount Foot (4) Latch (1) Ladder Hook (2) Ladder Stop (2)

Torque Tube (1)

Ladder Pan Stiffener (1)

Mount Rail (2)

Handle Assy. (1)

1

Hardware Pack Cont'

5/16"-18 x 1" Hex Bolt

3/8" Lock Washer

1/4"-20 x 7/8" Fully Threaded Hex Bolt

1/4" Washer

1/4"-20 Nyloc Nut

M8 x 25mm Hex Bolt

M8 x 20mm Counter Sink Bolt

Joint Sealant

40933 Hardware List

Hardware Pack

(
Qt

5/16"-18 x 3/4" Carriage Bolt

5/16" Flat Washer

5/16" Lock Washer

5/16"-18 Nyloc Nut

5/16"-18 x 5/8" Hex Bolt

Round Rubber pad

Fender Washer - 24mm OD x 2mm TK

M8 Nyloc nut

Tools Needed

8' Tape Measure 1/2" End Wrench
1/2" Socket 9/16" End Wrench
9/16" Socket Hammer
7/16 Socket

(i)
Qty 4 -

(j)
Qty 8 -

3/8"-16 x 3/4" Hex Bolt

a)

y 6 -

(b)
Qty 26 -

( c)
Qty 8 -

(d)
Qty 14 -

(e)
Qty 4 -

(k)
Qty 8 ­3/8" Flat Washer

(l)
Qty 8 -

(m)
Qty 6 -

(n)
Qty 12 -

(o)
Qty 6 -

(f)
Qty 4 -

(g)
Qty 4 -

(h)
Qty 4 -

For TECHNICAL SUPPORT Call: 800-343-7486 Monday - Friday 7:00 A.M. to 4:00 P.M (PST)

(p)
Qty 4 -

(q)
Qty 2 -

(r)
Qty 1 -

2

Step 1

Mount rail to roof using M8x25 Bolts with flat and lock washers (on 2014 Transit Connect use nyloc nut with fender washer and rubber
washer-Do not use lock washer). Mount rail so that the end of the rail is 1-2” approximately (usually the 2
for 2013 and older Transit Connect) from where the rear door opening is.

nd

or 3rd hole-Use countersunk hole

Step 2

Measure width the rail and bolt feet to bows at that approximate location as shown, DO NOT TIGHTEN at this point.

3

Step 3

Bolt “Latch” as shown using 5/16”x3/4” carriage bolts with nyloc nuts and flat washers.

Step 4

Next bolt the Angle bracket on the driver side of the bows using 5/16”x3/4” carriage bolts with nyloc nuts and flat washer as
shown.

4