ENGLISH
INSTALLATION MANUAL
* "CompactFlash(TM)" is the registered trademark of SanDisk Corporation, U.S.A.
|
CONTENTS |
|
1. CHECK AT THE BEGINNING..................................................................... |
1 |
|
(1) |
Control box to be used............................................................................................. |
1 |
(2) |
List of parts to be used............................................................................................. |
1 |
2. SETUP OF THE HARDWEAR..................................................................... |
1 |
|
(1) Attaching the circuit board....................................................................................... |
1 |
|
3. SETUP OF THE SOFTWARE...................................................................... |
3 |
|
(1) |
Checking procedure of the software version......................................................... |
3 |
(2) |
Rewriting procedure of the software by means of IP-110...................................... |
4 |
1) Common procedure........................................................................................................................... |
4 |
|
2) Rewriting procedure of the software of IP-110............................................................................... |
5 |
|
3) Rewriting procedure of the software of main shaft ....................................................................... |
7 |
|
There are cases where the control box to be used |
|
Fig. A |
||
may not be utilized. Check that REV. No. 1 as |
||
|
||
|
shown in Fig. A is after "02". If the number is before |
|
|
it, the control box cannot be used. |
1
On the occasion of using DLU-5494N-7/IP-110C, check that the products (parts) below are on hand.
1.DLU-5494N-7 machine head
2.IP-110C panel
3.SC-910 control box
4.M-91 motor
5.Extension p.c.b (KT-01(EPF) p.c.b.) for DLU-5494N-7
When the parts to be used are ready, install the extension p.c.b. on SC-910 following the procedure below.
Inserting position
2
1.Open the front cover and upper cover according to the instructions given in the Instruction Manual for the control box main unit.
2.Insert stud 2 supplied with the unit as accessories to KT-01(EPF) p.c.b. A (asm.) 1.
Be careful of the inserting direction.
Rear side1
– –