JAMO R-300 User Manual

R-300

WARNING: Improper installation could result in damage to the re-

ceiver. Read all instructions before installation.

Introduction

The R-300 has its electronics housed in a brass cylinder. The front
end of the unit is a small round lens. This small receiver is designed
to be placed in very tiny spaces. One example is a small corner of an
equipment cabinet, or in the front baffle of the Jamo in-wall
speakers. A single ½-inch hole will accommodate the R-300. The
high sensitivity of this receiver gives you the ability to place the R­300 further away from the hand held remote, increasing the
placement options you have.

CONNECTING THE RECEIVER

Use the supplied screw terminal block to extend cables to the
connecting block

USING THE RECEIVER

To use the system, simply point the hand-held remote control trans­mitter at the window on the R-300 receiver and press the proper
button. The R-300 does not change the way your remote control
works. The hand-held remote control transmitter for the stereo re­ceiver will only operate the stereo receiver. Likewise, other trans­mitters will only operate their companion devices.
The maximum distance between the transmitter and the R-300 re­ceiver will be different for each transmitter and when used directly
with the controlled device.
The system may be left on continuously, as it does not affect the
normal operation of the remote controlled device and consumes
very little power.