MODEL ST01 Series Self-Adjusting Wall Switch Timer
Easy-Set Guide
This Easy-Set Instruction Sheet may be helpful in setting up common timer programs. Refer to the Installation and User Instructions Sheet for more information.
To Clear the Timer
1.Press and hold down the ON/OFF button.
2.Using a paper clip or pen, press and release the RESET button, which is to the lower right of the + button.
3.Continue holding ON/OFF until you see INIT on the screen.
4.Release ON/OFF.
5.Wait until you see 12:00 am in MANual mode.
Setting the Time and Date 
1.Press MODE to display SETUP.
2.Press ON/OFF.
3.Press + or – to set your hour for the current time of day.
4.Press ON/OFF.
5.Press + or – to set your minutes for the current time of day.
6.Press ON/OFF.
7.Press + to advance the year if needed.
8.Press ON/OFF.
9.Press + or – to change the month.
10.Press ON/OFF.
11.Press + or – to change the date.
12.Press ON/OFF. Make sure it’s the correct day of the week. If not, go back and check the year.
13.Press ON/OFF to choose DST (Daylight Saving Time)
•Press + to select Man if you do not observe DST, or
•Press + again to select Auto to automatically set for DST.
14.Press ON/OFF to choose zone.
15.Press + to select your zone. (Refer to map in the Install Sheet for proper zone).
16.Press ON/OFF to review Dawn time.
17.Press ON/OFF twice to review Dusk time.
18.Press ON/OFF twice to save.
Programming Dusk ON/Dawn OFF
1.Press MODE to display PGM.
2.Press ON/OFF three times to choose DUSK.
3.Press ON/OFF to choose the days you need, then press + to change days from ALL, M-F, WeeKenD, or individual day.
4.Press ON/OFF to SAVE your work.
5.Press + to go to Program 2.
6.Press ON/OFF twice to display DAWN.
7.Press ON/OFF to choose the days you need, then press + to change days from ALL, M-F, WeeKenD, or individual day.
8.Press ON/OFF to SAVE your work.
9.Press MODE to display AUTO.
Programming Dusk ON/Fixed Time OFF 
1.Press MODE to display PGM.
2.Press ON/OFF three times to choose DUSK.
3.Press ON/OFF to choose the days you need, then press + to change days from ALL, M-F, WeeKenD, or individual day.
4.Press ON/OFF to SAVE your work.
5.Press + to go to Program 2.
6.Press ON/OFF twice to display DAWN.
7.Press + until you get to 12:00 pm.
8.Press ON/OFF.
9.Press + or – to set the hour of the OFF time.
10.Press ON/OFF.
(Continued on the back)
Loading...