Model: T1905 |
LR3730 |
PROGRAM TIME SWITCH
FOR UP TO 48 TIMING OPERATIONS 0N 24 HOUR SCHEDULE
SINGLE POLE DOUBLE THROW
SWITCH RATING: 20 AMP. 125-480 VOLTS A.C. 1/2 HP-125V 1 HP-250V.
|
CLOCK MOTOR: 125 VOLTS - 60 HZ. |
|
|||
|
TIME |
|
CLOCK |
|
|
|
|
MOTOR |
|
|
|
|
DIAL |
|
|
|
|
MANUAL |
|
N.O. |
N.C. |
COM. CLOCK |
N.C. |
|
|
|
|
||
LEVER |
|
SUPPLY |
|
|
LOAD |
|
|
|
NO. |
||
CAP |
|
|
|
|
|
|
|
|
|
LOAD |
|
NUTS |
INSULATOR |
|
NORMALLY CLOSED CIRCUIT |
||
|
|
|
NORMALLY OPEN CIRCUIT |
|
FIG. 1 |
WIRING DIAGRAM |
WIRING INSTRUCTIONS
This Time Switch can be wired to control two circuits as Single Pole Double throw, or to control one circuit as Single Pole Single Throw. Either normally open (NO) or normally closed (NC). To wire switch see wiring diagram above.
1.TO PROGRAM TIME SWITCH, Depress tripper(s) into dial at desired time(s) operation(s) is/are required.
•ON TIME: First tripper turns on the load for 16-20 minutes. Each additional tripper will lengthen the on time by 15 minutes.
•OFF TIME: First tripper in raised position turns off the load for
10-14 minutes.Each additional space will lengthen the of time by 15 minutes.
2.SET TIME-OF-DAY: Turn dial in clockwise direction only and align the exact time-of-day (the time now when switch is being put into operation) to the “TIME” arrow on insulator.
OPERATING INSTRUCTIONS
TO CONTROL LOADS MANUALLY, Move manual lever (See Figure 1) up. This lever will close normally open circuit and open the normally closed circuit. To return, to automatic control, move lever back to its original position .
IN CASE OF POWER FAILURE, reset dial. See step (2) of programming instructions.
INTERMATIC INCORPORATED
SPRING GROVE, ILLINOIS 60081-9698
158TS10970