Item # _____________________________________
Quantity ___________________________________
C.S.I. Section 11400
SR24
701 S Ridge Avenue, Troy, OH 45374
1-888-4HOBART • www.hobartcorp.com
STANDARD FEATURES
■ SR24H - 19 racks per hour;
SR24C - 14 racks per hour
■ Hot water or chemical sanitizing
■ 70°F rise booster heater on SR24H
■ 16 gauge stainless steel tank bottom with 18
gauge stainless steel base, chamber and door
■ Pumped nal rinse
■ Stainless steel lower front panel
■ SR24H - 2.4 gallons per rack
SR24C - 2.4 gallons per rack
■ Cord and plug (SR24C model)
■ Revolving upper and lower anti-clogging
wash/rinse arms
■ Removable stainless steel scrap screen
DISHMACHINE
MODELS
❑ SR24H – High Temperature Sanitizing
❑ SR24C – Chemical Sanitizing
ACCESSORIES - eld installed
❑ Detergent and/or rinse agent pump (chemical
sensing device suggested)
❑ Chemical sensing device (SR24H only)
❑ Stainless steel top and side panels
❑ Stainless steel base with 6" legs
❑ 17" stainless steel stand
❑ Pressure regulator valve
Specications, Details and Dimensions on Inside and Back.
■ Automatic ll
■ Corrosion resistant pump
■ Flexible ll and drain hoses supplied
■ Automatic pumped drain
■ 165⁄8" high door opening
■ Two dishracks – one peg and one combination
■ Chemical sensing module (SR24C)
STANDARD VOLTAGES
❑ 120/60/1 (SR24C model only)
❑ 120/208(3W)/60/1 (SR24H model only)
❑ 120/240(3W)/60/1 (SR24H model only)
OPTIONS
❑ Detergent pump - factory installed
(chemical sensing module included)
SR24 DISHMACHINE
Model SR24H
Built in Booster 180°F Rinse
(Shown with optional side and top panels)
F-40028 – SR24 Dishmachine Page 1 of 4
SR24
DISHMACHINE
DETAILS AND DIMENSIONS
701 S Ridge Avenue, Troy, OH 45374
1-888-4HOBART • www.hobartcorp.com
Page 2 of 4 F-40028 – SR24 Dishmachine
SR24
701 S Ridge Avenue, Troy, OH 45374
1-888-4HOBART • www.hobartcorp.com
DISHMACHINE
INSTALLATION REQUIREMENTS AND INSTRUCTIONS
1. A single ll and rinse pipe connection is required. 6' ex hose supplied.
2. The electrical connection location for a 3⁄4" electrical connector (11⁄8" diameter hole) is provided for the
SR24H model only.
3. The required electrical cord and plug are supplied on the SR24C model only.
4. Important: The sodium hypochlorite container should be placed on the oor (SR24C model only).
5. If the sodium hypochlorite container is to be placed in a cabinet adjacent to the machine, a 1⁄2" diameter
hole is required in the cabinet to run the bleach supply line through.
6. Pumped drain 3⁄4" MPT tting 10' hose supplied.
7. A supply line strainer is required. (By others)
8. If water owing pressure is over 28 psi, install a PRV (not supplied). If water owing pressure is under
22 psi, the supply line pressure must be increased.
F-40028 – SR24 Dishmachine Page 3 of 4
SR24
DISHMACHINE
SPECIFICATIONS
DESIGN: Front opening, equipped with stainless steel
front. Freestanding Models – Top and side panels are
optional. Undercounter Models – Not equipped with side
or top panels. Adjustable feet lower overall height to 345⁄8"
minimum and raise it to 355⁄8" maximum.
CONSTRUCTION: 16 gauge stainless steel tank bottom
with 18 gauge stainless steel base, chamber and door.
PUMP: Centrifugal-type, integral with motor, vertically
mounted. Pump capacity is 45 U.S. gallons per minute.
MOTOR: Built to Hobart specications, 1⁄2 H.P., single
phase, furnished for 120/60/1, 120/208(3W)/60/1 or
120/240(3W)/60/1 electrical specication. Factory sealed
lubrication.
RACKING: Will accommodate most racks from 10" x 20"
(half racks) to 20" x 20". Will also accept 16" x 18"
cafeteria trays.
WASH AND RINSE CYCLE: Completely automatic,
controlled by an electrically energized synchronous timer.
Closing the door actuates the operating cycle. When the
amber cycle light goes out, the operating cycle is complete
(185 seconds for the SR24H models and 215 seconds for
the SR24C model). The cycle may be interrupted at any
time by opening the door. Cycle continues when the door
is closed.
701 S Ridge Avenue, Troy, OH 45374
1-888-4HOBART • www.hobartcorp.com
WASH: Revolving upper and lower hydrosweep wash arms
with unrestricted openings provide thorough distribution of
water and are easily removed for cleaning. Uses a single
water ll connection.
RINSE AND SANITATION:
SR24H Model – Sanitation accomplished by means of a
built-in 7 kW electric booster (with stainless steel tank)
designed to raise the water to 180°F (based on incoming
water temperature of 110°F).
SR24C Model – Low temperature/chemical sanitizing:
Accomplished by lling the sump with 120°F fresh water
and pumping it through revolving wash arms. The required
amount of 6.0% sodium hypochlorite (liquid bleach) is
dispensed into the nal rinse water from a container to
achieve a minimum 50 PPM sanitizing solution. Injection
of the sodium hypochlorite is accurately accomplished
by a Hobart sanitizing chemical pump. The chemical
sensing module signals the operator by a ashing light
and a periodic alarm, when the sanitizer solution has been
depleted. The customer must supply sanitizer solution and
container. NOTE: NSF minimum 120°F.
MACHINE RATINGS SR24H SR24C
Racks per Hour 19 14
Dishes per Hour (average of 25 per rack) 475 350
Glasses per Hour (average of 45 per rack) 855 630
Overall Dimensions (width x depth x height) – inches
(without panels)
(with top & side panels)
Wash Motor – HP
Tank Capacity – U.S. Gallons 1.8 1.8
Pump Capacity – U.S. Gallons per minute – Weir Test 45 45
7 KW Electric Booster Heater Standard N/A
Sanitizing Chemical Pump with a Chemical Alarm N/A Standard
Hot Water
Consumption
at 22 psi
Hot Water
Consumption
at 28 psi
Minimum Flow Rate – U.S. Gallons per minute 4.5 4.5
Peak Rate of Drain Flow – U.S. Gallons per minute
(Initial rate with full tank)
Minimum Water Temperature – Wash Cycle
– Rinse Cycle
Shipping Weight Crated – Approximate lbs. 166 155
Minimum Hot Water Supply Temperature 110°F 120°F
Detergent Pump – If Factory Installed, a Chemical Alarm is Included Optional Optional
Rinse Aid Pump Accessory Accessory
Wash Cycle – U.S. Gallons per rack 1.2 1.2
Rinse Cycle – U.S. Gallons per rack 1.2 1.2
U.S. Gallons per hour 46 34
Wash Cycle – U.S. Gallons per rack 1.4 1.3
Rinse Cycle – U.S. Gallons per rack 1.4 1.3
U.S. Gallons per hour 53 36
As continued product improvement is a policy of Hobart, specications are subject to change without notice.
24 x 24 x 345⁄8 min. (355⁄8 max.)
24 x 24 x 3513⁄16 min. (3613⁄16 max.)
1
⁄2
10 10
150°F
180°F
24 x 24 x 345⁄8 min. (355⁄8 max.)
24 x 24 x 3513⁄16 min. (3613⁄16 max.)
1
⁄2
120°F
Page 4 of 4 F-40028 – SR24 Dishmachine
F-40028 (REV. 01/08) LITHO IN U.S.A. (H-01)
Loading...