Harman kardon AVR 745 SETTINGS WORKSHEETS

AVR 745 SETTINGS WORKSHEETS

SYSTEM DEFAULTS

The two tables in this section show the factory default settings for the Video Inputs and Video Sources. These tables give you a picture of the AVR 745’s initial settings. You may
then decide whether any item needs to be changed so that it is more appropriate for your specific installation. Any of the settings shown may be changed as shown in the
pages of the System Configuration section of the owner’s manual (pages 21–33).

TABLE 1: VIDEO INPUT DEFAULTS
INPUT AUDIO VIDEO COMPONENT TRIGGER 2 RECORD AUTO-POLL INPUT

INPUT INPUT VIDEO INPUT SETTING OUTPUT SOURCE TYPE
Video 1 ANALOG AUTO COMPONENT 1 ON ANALOG ON VCR
Video 2 ANALOG AUTO COMPONENT 2 ON ANALOG OFF CABLE DIGITAL
Video 3 OPTICAL 1 AUTO COMPONENT 1 ON ANALOG ON CABLE ANALOG
Video 4 OPTICAL 4 AUTO COMPONENT 2 ON ANALOG ON SATELLITE DIGITAL
DVD COAX 1 AUTO COMPONENT 3 ON ANALOG OFF DVD
HDMI 1 HDMI 1 HDMI 1 --- ON DSP DOWNMIX OFF *
HDMI 2 HDMI 2 HDMI 2 --- ON DSP DOWNMIX OFF *
Tuner ANALOG AUTO COMPONENT 1 ON ANALOG --- *
XM --- HDMI 1 COMPONENT 1 ON ANALOG --- *
CD ANALOG AUTO COMPONENT 3 ON ANALOG OFF *
Tape ANALOG AUTO COMPONENT 1 ON ANALOG OFF *
DMP/The Bridge ANALOG HDMI 1 COMPONENT 1 ON ANALOG --- *
6/8 CH Direct ANALOG HDMI 1 COMPONENT 1 ON ANALOG --- *
USB --- HDMI 1 COMPONENT 3 ON DSP DOWNMIX --- *

*: User should change setting to match input type.

TABLE 2: VIDEO SOURCE DEFAULTS

FEATURE DVD VCR CABLE DIG SAT DIG SAT ANALOG CABLE ANALOG CAMERA DIG CAMERA ANALOG
Noise Reduction OFF ON OFF OFF ON ON OFF ON
X-Color Suppressor ON ON ON ON ON ON ON ON
DCDi Interpolation ON ON ON ON ON ON ON ON
Film Mode Detect ON ON ON ON ON ON ON ON
Film Mode Edit Detect ON ON ON ON ON ON ON ON
Composite Video Enhancement ON ON ON ON ON ON ON ON
VCR Sync Time Enhancement ON ON ON ON ON ON ON ON

System Default and Personal Settings Worksheets

The worksheets in this section show the system defaults for the global settings on your AVR 745. Once your system is configured manually, or through the use of EzSet/EQ II,
where applicable, we recommend that you use the “Your System Settings” column to record your personal preferences so that they may be restored in the event the AVR’s
memory is lost due to an extended power outage, system upgrade, processor reset, or other major service to your unit.

Worksheet A: Video Monitor and Aspect Ratio Defaults and Settings

Feature/Display Type System Default Your System Setting
Display Interface Analog
HDMI Audio Out Off
CRT 4:3
Front Projection 4:3
Rear Projection 4:3
Plasma (PDP) 16:9
DLP™ 16:9
LCD 16:9

AVR 745 SETTINGS WORKSHEETS

Worksheet B: Surround Configuration Defaults and Settings

Feature System Default Your System Settings
Logic 7 Global On
Default Surround Original
Dolby Pro Logic II Music Center Width 3
Dolby Pro Logic II Music Dimension 0
Dolby Pro Logic II Panorama Off
Dolby Pro Logic IIx Music Center Width 3
Dolby Pro Logic IIx Music Dimension 0
Dolby Pro Logic IIx Panorama Off
Night Mode Off

Worksheet C: Delay Defaults and Setting

Feature System Default Your System Settings
Front Left 12.0 Feet
Center 12.0 Feet
Front Right 12.0 Feet
Surround Right 12.0 Feet
Surround Back Right 12.0 Feet
Surround Back Left 12.0 Feet
Surround Left 12.0 Feet
Subwoofers 12.0 Feet

Worksheet D: System Defaults and Settings

Feature System Default Your System Settings
Front L/R Speaker Size & X-Over Small – 100 Hz
Center Speaker Size & X-Over Small – 100 Hz
Surround L/R Speaker Size & X-Over Small – 100 Hz
Surround Back Speaker Size & X-Over None
LFE LP Filter 100 Hz

Sub Mode Sub L/R+LFE
Number of Subs 1
Channel Adjust Global
Sub Size 10 in/250 mm
VFD Fade Time Out Off
VFD Brightness Full
Volume Default Off
Volume Default Set -25dB
Semi OSD Time Out 5 Sec
Full OSD Time Out 20 Sec
DMP Auto Power Off
HDMI Video Auto On
Surround Back Amps Main
Carrier Out Zone II