
PCR Tube Strips and Cap Strips
0012 575.408-01/0909
Instructions for use

PCR Tube Strips and Cap Strips — Instructions for use
Instructions for use
Instructions for use
1 Product description
Instructions for use
PCR Tube Strips are thin-walled polypropylene disposable tubes. Cap Strips are tube
lids for PCR Tube Strips and for PCR Plates.
Both consumables are designated for use in routine, research and training labs in the
bioscience, industrial and chemical fields. They are only to be used by trained
specialists.
The vapor volume above the liquid is reduced by combining real-time PCR Tube
Strips and Masterclear Cap Strips. The system is therefore suitable for "low
Hint!
volume" PCR applications. Because of the construction of the Cap Strip the
maximum filling volume of the tubes is reduced from nominal 150 μL to 80 μL.
2Safety
Instructions for use
WARNING! Damage to health due to toxic, radioactive or aggressive
chemicals and infectious liquids and pathogenic germs.
Observe the national regulations for handling these substances, the
WARNING!
biological security level of your laboratory, the material safety data sheets
and the manufacturer's application notes.
Wear your personal protective equipment (PPE).
d
e
i
f
i
l
a
u
Q
WARNING! Damage to health due escaping substances.
In exceptional cases (e.g. high vapor pressure of the reagents) the tube lid
may burst open at increased temperatures, especially when the lid is not
WARNING!
properly sealed or the lip seal is damaged.
Only use undamaged and visibly perfect tubes.
Seal the tubes correctly. Do not damage the seal lip.
Observe the maximum filling volume. When opening the tubes, liquid at
the lid may splash out.
Prevent micro test tubes from tipping over: store in suitable micro test
tube racks.
Seal the PCR Tubes prior to centrifugation. Pay attention to the operating
manuals of the device when operating centrifuges or other devices.
Make adequate safety arrangements for the transport or storage outside
of the laboratory to prevent materials escaping the tubes.
Avoid contamination by taking adequate precautions after opening the bag of PCR
clean tubes.
Dispose reagents or micro test tubes contaminated by reagents and clean and
disinfect used materials according to the regulations by the laboratory.
2

PCR Tube Strips and Cap Strips — Instructions for use
3 Application
Example: real-time PCR Tubes and Masterclear Cap Strips.
A
A
1. Use gloves.
2. Place the Cap Strips with the optical surface downwards into the tube strip or the 96
PCR plate. To do this, use the alignment with the markings A and H.
3. Press the Cap Strips firmly onto the tubes.
For assistance use the accompanying tools. With the flat side the lids can be
selectively pressed onto the tube (see Fig.).
4. Check the right seating of the Cap Strips on the tube strips or the 96 PCR plates as
usual.
5. Because of the tight seal it is more difficult to open the Masterclear Cap Strips.
Therefore, move the lid strips sideways when pulling off after the PCR run. Thus, lid
after lid can be loosened in the well and taken off afterwards.
Instructions for use
H
H
d
e
i
f
i
l
a
u
Q
4 Technical data
Material Polypropylene, autoclavable (121 °C, 20 min) in open
Eppendorf PCR clean Certified free of RNase, DNase, human DNA and PCR
Centrifugability Can be centrifuged up to 10,000 x g in the 45° fixed-angle
Storage Protect from direct sunlight and UV-light.
Operational temperature -80 °C to +100 °C, autoclavable at 121 °C.
Instructions for use
state.
inhibitors*.
rotor.
Test conditions: 4 °C, 30 min, diluted saline solution with a
density of 1.2 g/mL.
PCR Tubes are not suitable for centrifugation of organic
solvents. In case of doubt please contact Eppendorf.
Store dry at room temperature.
* Certificates or test procedures and further information on request.
3

PCR Tube Strips and Cap Strips — Instructions for use
5 Ordering information
Order No.
(International)
0030 132.882 951022102
0030 124.804 0030124804
0030 132.874 951022089
0030 124.839
0030 124.847
0030 132.890 951022109
0030 124.812 0030124812
0030 124.820 0030124820
0030 124.545 0030124545
Instructions for use
Order No.
(North America)
0030124839
0030124847
Description
real-time PCR Tube Strips
0.1 mL, without caps, 10 x 12 strips
PCR Tube Strips
0,1 mL, without caps, 10 x 12 strips
Masterclear Cap Strips
10 x 12 strips
Cap Strips
domed, 10 x 12 strips
flat, 10 x 12 strips
real-time PCR Tube Strips and Masterclear
Cap Strips
10 x 12 strips each
PCR Tube Strips and Cap Strips, domed
10 x 12 strips each
PCR Tube Strips and Cap Strips, flat
10 x 12 strips each
PCR Rack
10 pcs.
Your local distributor: www.eppendorf.com/worldwide
Eppendorf AG · 22331 Hamburg · Germany · Tel: +49 40 538 01-0 · Fax: +49 40 538 01-556
Eppendorf North America, Inc. · One Cantiague Road · P.O. Box 1019
Westbury, N.Y. 11590-0207 · USA · Tel: +1 516 334 7500 · Toll free phone: +1 800 645 3050
E-Mail: eppendorf@eppendorf.com
Fax: +1 516 334 7506 · E-Mail: info@eppendorf.com
eppendorf is a registered trademark.
0012 575.408-01/0909