Eaton Transmission AutoShift Gen3 Service Manual

Fuller® Automated Transmissions
OFF ON
OFF ON
OFF ON
Fuller® Automated Transmissions
More time on the road
Fault Code Retrieval/Clearing AutoShift™ Gen3
Retrieving Fault Codes
1. Place the shift lever in neutral.
2. Set the parking brake.
3. Turn the ignition key ON but do not start the engine. If the engine is already running, you may still retrieve codes, however, do not engage the starter if engine stalls.
4.
To Retrieve Active Codes: Start with the key in the ON position. Turn the key OFF and ON two times within five seconds ending with the key in the ON position. After five seconds, the gear display begins flashing two-digit fault codes. If there are no active codes the gear display will show code 25, followed by PD (Product Diagnostic mode). The vehicle will not start in PD mode. You must turn vehicle key OFF and allow the system to power down to exit PD mode before restarting.
and wait for the transmission to power down.
5. To Retrieve Inactive Codes: Start with the key in the ON position. Turn the key OFF and ON four times within five seconds ending with the key in the ON position. After five seconds, the gear display begins flashing two-digit fault codes. If no codes are active, the gear display will flash code 25 (no codes).
6. Two digit fault codes will be displayed in the gear display. Record the codes. A one or two second pause separates each stored code, and the sequence automatically repeats after all codes have been flashed.
Clearing Fault Codes
1. Start with the key in the ON position. Turn the key OFF and ON six times within five seconds, ending with the key in the ON position.
Note: If the codes have been successfully cleared,
the service lamp will come on and stay on for five seconds.
2. Turn the key OFF and allow system to power down.
To start engine turn key off
2 TIMES
4 TIMES
6 TIMES
TM
More time on the road
Fault Code Index AutoShift™ Gen3
Fault Codes Description
11 No ECU. Operation Test 12 Improper ECU Configuration 13 J1939 Control Device 14 Invalid Shift Lever Voltage 16 High Integrity Link 17 Start Enable Relay 25 NO CODES 26 Clutch Slip 27 Clutch Disengagement 28 Clutch System 31 Momentary Engine Ignition Interrupt Relay MEIIR 32 Loss of Switch Ignition Power Test 33 Low Voltage Supply 34 Weak Battery Voltage Supply 35 J1939 Communication Link 36 J1939 Engine Message Test 37 Power Supply 41 Range Failed to Engage 42 Splitter Failed to Engage 43 Range Solenoid Valve 44 Inertia Brake Solenoid Coil 45 Inertia Brake Performance 46 Splitter Solenoid Valve 51 Rail Position Sensor 52 Gear Position Sensor 56 Input Shaft Sensor 57 Main Shaft Sensor 58 Output Shaft Sensor 61 Rail Select Motor 63 Gear Select Motor 71 Unable to Disengage Gear 72 Failed to Select Rail 73 Failed to Select Gear 74 Engine Failed to Respond 75* Power Down in Gear 83 Shift Lever Missing 84 Shift Controller Device Not Configured 85 Shift Control Device Incompatible
An 88 may appear in the gear display which indicates self testing. *This code only set inactive.
©2006 Eaton Corporation · All rights reserved. Printed in Australia. EA10425AU 10/07
Eaton Truck Components, Kilsyth, Victoria, 3137 Australia.
TM
www.roadranger.com
Loading...