Denon DN-X800 Service Manual
Specifications and Main Features
- Type of Color Printer: DNP-DN8
- Outer Dimensions: 482 x 105 x 177 mm (without feet)
- Weight: 5.5 kg
- Input Voltage: 120 VAC
- Rated Power: 20 W
- Applicable Conditions:
- Operating Ambient Temperature: 5 – 35 °C (41 – 95 °F)
- Operating Relative Humidity: 25% – 85% (non-condensing)
- Non-operating Ambient Temperature: -20 – 60 °C (4 – 140 °F)
- Name of the Inputs/Outputs:
- Primary Chemistry – Mic & Wires:
- Specific Tuner for Main Mic: -54 dBV (2.0 mV)
- Specific Tuner for Aux Mic: -60 dBV (1.0 mV)
- Effect (Return) -14 dBV 200 mV
- 3-Phono -50 dBV 3.0 mV
- 8-Line -14 dBV 200 mV
- Per Type of Output Tuner:
- Main K + (Balanced) +4 dBm (1.23 V)
- Main K + (Unbalanced) 0 dBV (1.0 V)
- Zone (Balanced) +4 dBm (1.23 V)
- Booth (RCA) +6 dBV (2.0 V)
- Tape (RCA) -10 dBV (316 mV)
- Effect (Send) -14 dBV (200 mV)
- Subwoofer -2 dBV (800 mV)
- Headphone -4 dBV (630 mV)
- Pass Through Frequencies:
- For The Line: 20 until 20kHz
- For Phono: 20 until 20kHz
- For Mic: 20 until 20 kHz
- Ratio of Signal to Noise:
- Depending on Line the rate is 80 dB
- The rate is 75 dB depending on Phono.
- Main Mic: 65 dB
- Total Harmonic Distortion Rate:
- Line: Below 0.05%
- Phono: Below 0.05%
- Cross Talk: Over 70 dB
- Channel Equalizer:
- H: +10 dB, –26 dB (13 kHz)
- M: +10 dB, –26 dB (1 kHz)
- L: +10 dB, –26 dB (100 Hz)
- Microphone Equalizer:
- Hi: +12 dB, -12 dB (10 kHz)
- Mid: +12 dB, -12 dB (1 kHz)
- Low: +12 dB, -12 dB (100 Hz)
- Digital Input:
- Input Sensitivity: -20 dBV(100 mV)
- Signal Format: SPDIF
- Output Level: 0.5 Vp-p 75 ohms
- Digital Output:
- Signal Format: IEC958 Type II
- Output Level: 0.5 Vp-p 75 ohms
- Output Signal Level: -6 dB
Frequently Asked Questions
Q: What is the power supply requirement for the DN-X800?
A: The DN-X800 requires a power supply of 120 VAC.
Q: What are the dimensions of the DN-X800?
A: The dimensions are 482 (W) x 105 (H) x 177 (D) mmexdc (without feet).
Q: How much does the DN-X800 weigh?
A: The DN-X800 weighs 5.5 kg.
Q: What is the frequency response range of the microphone input?
A: The microphone input has a frequency response range of 20 to 20 kHz.
Q: What is the highest wattage needed for the DN-X800?
A: The total power requirements do not exceed 20 watts.
Q: Main microphone input but how much sensitivity does it have?
A: The microphone power -54 dBV (2.0 mV) has input sensitivity which is really high.
Q: Are you able to use this equipment in areas with high levels of humidity?
A: You should be able to use it in an environment with relative humidity between 25 and 85 without condensation.
Q: What does the SNR (rms) represent for the line input?
A: The line input has a noise at 80 dB.
Q: If I was to use it what is the distortion for the audio output?
A: Both the line and phono inputs contain a low total harmonic distortion of less than 0.05%.
Q: Can you tell me what formats are supported for the digital input for the DN-X800?
A: As for the DN- X800 can the digital input be in spdif format.
User Manual
Loading...