cybelec DNC600S User Manual

DNC 600S

The DNC 600S numerical control is intended
specifically for sheet-metal bending.

Depending on the software installed, it will be used
on synchronized or conventional press brakes with
mechanical or hydraulic end stops.

The DNC 600S is a competitively-priced product
in a robust panel or box-design construction.
It is a high integration of functions fitted out with
a vivid high-contrast monochrome screen and a
simplified keyboard with large keys.

DNC 600S

Easy Operating

• Ergonomic

– Large, vivid and high-contrast 9,4" screen

– 2D Graphic representation of the part, including
gauging points

– Clear display of all the information the operator needs

– Rapid data input with the ergonomic keyboard equipped
with large keys

• User-friendly

– Complete programming of parts in a single page

– Intuitive and quick set-up of the machine with direct
access to set-up parameters in the Easy Bend page

– Contextual help and warning pop-up

– Simple pages

Better Bending

• Higher productivity with the 2D graphic display and the
easy and rapid modifi cations of existing products

• Very fi ne tuning through extensive machine parameters

• Programs can be linked together to create a very high
number of sequences

Powerful

• All basic functions available e.g.

– 2D Graphic L-alpha programming

– External or internal fl ange dimension calculation

– Automatic calculation of the top dead centre

– Deep integration with safety systems (messages, popup)

• EC safety-cycle management

• Great service features

– Internal backup of the machine data for immediate on
site service/diagnostic

• Easy communication
– Connection to your PC / notebook via RS 232

– Updating and data back-up

– Back-up software included

• Over 20 languages available

Cybelec S.A. • Rue des Uttins 27 • CH-1401 Yverdon-les-Bains
Tel. [phone] • Fax [phone] • [e-mail]
www.cybelec.ch