GETTING STARTED
WITH YOUR NEW DISHWASHER
FREQUENTLY ASKED
QUESTIONS
STEP 1- ADDING RINSE AGENT
For Proper Drying Always use Rinse Agent even if your detergent containes Rinse Agent
Rinse Agent
Level
• Lift tab to
open
• Add Rinse Agent when the light
on the control panel illuminates
or (Model Dependent)
Rinse Agent Level indicator on
the dispenser changes to a
light silver color
• To add Rinse Agent
Decrease
for
glasses
Arrow
Turn
Increase
for
Spots on
glasses
pour on the arrow
• Turn arrow to
adjust the amount
of rinse agent
dispensed
Streaks on
STEP 2 - ADDING DETERGENT
• Use fresh powdered detergent
for best results
• 1 tablespoon will clean most loads
• 3 tablespoons Max, do not overfi ll
• When using detergent tabs, lay
them fl at to avoid contact with the
cover
1
Slide cover fully left
Push rear of cover down
2
fi rmly until you hear the
CLICK
1
3 TBS MAX
2 TBS (25 ML)
1 TBS (15 ML)
2
• Add
Detergent
• To close
Run Time
To save energy, this dishwasher has a "Smart Control" that automatically adjusts the cycle based on soil loads and incoming
water temperature. The "Smart Control" makes decisions that can
cause the cycle time and water usage to adjust at discrete times,
and suddenly change in midcycle. The cycle times listed in the
Use and Care manual are based on normal soil loads and 120°F
incoming water and will vary based on your actual conditions.
When is the Cycle Complete
Depending on model you can tell when your unit has completed
the cycle in one of the following ways. Please refer to your Use
and Care manual for complete details
• Countdown Display at "0"
• Clean Light illuminates
• Cycle completion signal sounds (tone adjustable)
• Cycle indicator light that shines on fl oor goes out
Canceling a Cycle
Be careful of splash-out.
To cancel a cycle in process, press and hold the two buttons
labeled "Cancel Drain" for 3 seconds. Re-start the dishwasher
as normal
Cancel Drain
• If you should
need to open
the cover
• Push the blue button in
(NOT DOWN)
To Contact Customer Service
STEP 3 - TO START THE DISHWASHER
Exposed
Front
Controls
Hidden Top
Controls
2) Turn on
2) Turn on
1) Close the door
4) The unit will
then start
3) Select a cycle
1) Open the door
4) Close the
door to start
3) Select a cycle
With the dishwasher door open, locate the label on the right side
of the door. There you will fi nd the:
• Model Number
• Serial Number (FD#########)
• Toll Free Customer Service Phone Number
ALWAYS READ YOUR USE AND CARE MANUAL FOR DETAILED INSTRUCTIONS AND
IMPORTANT SAFETY NOTICES.
9000121317 Rev. B • 02/06