OBJ_DOKU-24112-003.fm Page 1 Friday, November 16, 2012 10:14 AM
Robert Bosch GmbH
Power Tools Division
70745 Leinfelden-Echterdingen
Germany
www.bosch-garden.com
F 016 L70 768 (2012.11) O / 10 XXX
Rotak
32
en Original instructions
OBJ_BUCH-1349-003.book Page 2 Friday, November 16, 2012 10:13 AM
2 | English
Children should be supervised to ensure that they do not
English
Safety Notes
Warning! Read these instructions carefully, be familiar
with the controls and the proper use of the machine.
Please keep the instructions safe for later use!
Explanation of symbols
General hazard safety alert.
Read instruction manual.
Pay attention that bystanders are not injured
through foreign objects thrown from the machine.
Warning: Keep a safe distance from the machine
when operating.
Caution: Do not touch rotating blades. Sharp
blade(s). Beware of severing toes or fingers.
Switch off and remove plug from mains before adjusting, cleaning or if the cable is entangled and
before leaving the garden product unattended for
any period. Keep the supply flexible cord away
from the cutting blades.
Wait until all machine components have completely stopped before touching them. The blades
continue to rotate after the machine is switched
off, a rotating blade can cause injury.
Do not use the machine in the rain or leave it outdoors when it is raining.
Beware electric shock hazard.
Keep supply flexible cord away from cutting
means.
Operation
Never allow children or people unfamiliar with these in-
structions to use the machine. Local regulations may restrict the age of the operator. When not in use store the
machine out of reach of children.
This machine is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use
of the machine by a person responsible for their safety.
play with the machine.
Never mow while people, especially children or pets, are
nearby.
The operator or user is responsible for accidents or haz-
ards occurring to other people or their property.
Do not operate the machine when barefoot or wearing
open sandals, always wear substantial footwear and long
trousers.
Thoroughly inspect the area where the machine is to be
used and remove all stones, sticks, wires, bones and other
foreign objects.
Before using, always visually inspect to see that the
blades, blade bolts and cutter assembly are not worn or
damaged. Replace worn or damaged blades and bolts in
sets to preserve balance.
Mow only in daylight or in good artificial light.
Avoid operating the machine in wet grass, where feasible.
Walk, never run.
Never operate the appliance with defective guards or
shields, or without safety devices, for example deflectors
and/or grass catchers in place.
Working on banks can be dangerous.
– Do not mow excessively steep slopes.
– Always be sure of your footing on slopes or wet grass.
– Mow across the face of slopes – never up and down.
– Exercise extreme caution when changing direction on
slopes.
– Use extreme caution when stepping back or pulling the ma-
chine towards you.
– Never mow by pulling the mower towards you.
Stop the blades if the machine has to be tilted for transpor-
tation when crossing surfaces other than grass and when
transporting the machine to and from the area to be
mowed.
Do not tilt the machine when starting or switching on the
motor, except if the machine has to be tilted for starting in
long grass. In this case, do not tilt it more than absolutely
necessary and tilt only the part which is away from the op-
erator. Always ensure that both hands are in the operating
position before returning the machine to the ground.
Switch on the motor according to the instructions with feet
well away from rotating parts.
Do not put hands or feet near or under rotating parts.
Always stand clear of the discharge zone when operating
the machine.
Never pick up or carry the machine while the motor is run-
ning.
Keep supply cables and extension cables away from
the blade. The blade can cause damage to the cables and
lead to contact with live parts. Beware electric shock haz-
ard.
Remove the plug from the socket:
– whenever you leave the machine,
F 016 L70 768 | (16.11.12) Bosch Power Tools
OBJ_BUCH-1349-003.book Page 3 Friday, November 16, 2012 10:13 AM
– before clearing a blockage,
– before checking, cleaning or working on the machine,
– after striking a foreign object. Inspect the machine for
damage and make repairs as necessary,
– if the machine starts to vibrate abnormally (check immedi-
ately).
Power supply
The voltage indicated on the rating plate must correspond
to the voltage of the power source.
We recommend that this equipment is only connect ed into
a socket which is protected by a circuit-breaker that would
be actuated by a 30 mA residual current.
Only use or replace power supply cables for this unit which
correspond to the types indicated by the manufacturer.
See the operating instructions for the order no. and types.
Never touch the mains plug with wet hands.
Do not run over, crush or pull the power supply cable or ex-
tension lead, otherwise it may be damaged. Protect the cable from heat, oil and sharp edges.
The extension lead must have a cross section in accord-
ance with the operating instructions and be protected
against splashed water. The connection must not be in water.
Always wear gardening gloves when handling or working near
the sharp blades.
Electrical Safety
Warning! Switch off, remove plug from mains before
adjusting, cleaning or if cable is cut, damaged or entangled.
The blades continue to rotate for a few seconds after
the machine is switched off.
Caution – do not touch the rotating blade.
Your machine is double insulated for safety and requires no
earth connection. The operating voltage is 230 V AC, 50 Hz
(for non-EU countries 220 V, 240 V as applicable). Only use
approved extension cables. Contact your Bosch Service Centre for details.
It is recommended for increased electrical safety to use a Residual Current Device (RCD) with a tripping current of not
more than 30 mA. Always check your RCD every time you use
it.
For products not sold in GB:
WARNING: For your safety, it is required that the plug attached to the machine is connected with the extension cord.
The coupling of the extension cord m ust be protected against
splash water, be made of rubber or coated with rubber. The
extension cord must be used with a cable strain relief.
The connection lead must be inspected for signs of damage at
regular intervals and may only be used if in perfect condition.
If the supply cord is damaged, it must be replaced by a Bosch
Service Centre.
Products sold in GB only: Your product is fitted with an
BS 1363/A approved electric plug with internal fuse (ASTA
approved to BS 1362).
If the plug is not suitable for your socket outlets, it should be
cut off and an appropriate plug fitted in its place by an authorised customer service agent. The replacement plug should
have the same fuse rating as the original plug.
The severed plug must be disposed of to avoid a possible
shock hazard and should never be inserted into a mains socket elsewhere.
Products sold in AUS and NZ only: Use a residual current device (RCD) with a rated residual current of 30 mA or less.
Maintenance
Always wear gardening gloves when handling or work-
ing near the sharp blades.
Keep all nuts, bolts and screws tight to be sure that the ma-
chine is in safe working condition.
Check the grass catcher frequently for wear or deteriora-
tion.
Examine the machine and replace worn or damaged parts
for safety.
Ensure replacement cutting means of the right type are
used.
Ensure replacement parts fitted are Bosch approved.
Extension cords/leads should only be used if they comply
with H05VV-F, H05RN-F types or IEC type design (60227
IEC 53, 60245 IEC 57).
If you want to use an extension cable when operating your
product, only the following cable dimensions should be used:
–1.0mm
–1.5 mm
–2.5 mm
2
: max. length 40 m
2
: max. length 60 m
2
: max. length 100 m
Note: If an extension cable is used it must be earthed and con-
Symbols
The following symbols are important for reading and understanding the operating instructions. Please take note of the
symbols and their meaning. The correct interpretation of the
symbols will help you to use the garden product in a better
and safer manner.
Symbol Meaning
nected through the plug to the earth cable of your supply network in accordance with prescribed safety regulations.
If in doubt contact a qualified electrician or the nearest Bosch
Service Centre.
WARNING! Inadequate extension cables can be dan-
gerous. Extension cable, plug and socket must be of
watertight construction and intended for outdoor use.
Cable connections should be kept dry and off the ground.
English | 3
Movement direction
Reaction direction
Bosch Power Tools F 016 L70 768 | (16.11.12)
Loading...