Apple 073-0581 User Manual

K iBook

Keyboard

Replacement Instructions

Be sure to follow the instructions in this sheet carefully. Failure to follow
these instructions could result in damage to your equipment and may void
your warranty.

Replacing the keyboard in your computer requires three basic steps:

• Turn off the computer.

• Remove the keyboard.

• Install the new keyboard.

Note:

A video version of the installation instructions is available at

http://www.info.apple.com/installparts

Tools Required

• Jeweler’s flat-blade screwdriver

• Phillips screwdriver

Electrostatic Discharge (ESD)

Static electricity, a normal and natural phenomenon, builds up on your body
as you walk around. You experience an electrostatic discharge (ESD) when
you touch an object and feel a spark. ESD can cause damage to the
internal components of your computer. To avoid ESD damage, read and
follow all instructions.

073-0581

Removing the Installed Keyboard

1 Place your computer on a clean, flat surface. Shut down your computer,

then disconnect all cables.

2 Turn over the computer and with a flat-blade screwdriver or a coin, turn

the battery screws counterclockwise to release the battery door. Pull
the battery pull tab to remove the battery.

3 Release the keyboard by sliding the two plastic tabs away from the

display.

Note:

If the keyboard does not pop up, it may be locked. Locate the
keyboard lock next to the num lock key. Use a flat-blade screwdriver to
turn the lock a half turn in either direction until you can slide the plastic
tabs away from the display.

Tab

Keyboard
Lock

Tab

2

- iBook Keyboard