Apple 073-1058 User Manual

0 (0)
 Mac Pro
Hard Drive
Replacement Instructions
Follow the instructions in this document carefully. Failure to follow these instructions could damage your equipment and void its warranty.
Note: Mac Pro can accommodate four serial ATA (SATA) 3 Gbps hard drives in its four internal
hard drive bays. In most congurations, a single hard drive occupies the far left bay (bay 1). The hard drives must meet the following specications:
Type: SATA 3 Gbps
Width: 3.9 inches (102 mm)
Depth: 5.7 inches (147 mm)
Height: 1.0 inch
Tools Required
The only tool required for this procedure is a Phillips #1 screwdriver.
Opening the Computer
Shut down the computer.
1.
Warning: Always shut down the computer before opening it to avoid damaging its internal components or the components you are installing. Do not open the computer or attempt to install items inside it while it is on.
Wait 5 to 10 minutes to allow the computer’s internal components to cool.
2.
Warning: After you shut down the system, the internal components can be very hot. You must let the computer cool down before continuing.
Unplug all external cables from the computer except the power cord.
3.
Touch the metal PCI access covers on the back of the computer to discharge any static
4.
electricity from your body.
Important: Always discharge static before you touch any parts or install any components inside the computer. To avoid generating static electricity, do not walk
around the room until you have nished working and closed the computer.
073-1058 Rev. B
Unplug the power cord.
5.
Hold the side access panel and lift the latch on the back of the computer.
6.
Warning: The edges of the access panel and the enclosure can be sharp. Be very careful when handling them.
Remove the access panel and place it on a at surface covered by a soft, clean cloth.
7.
Mac Pro Hard Drive 2
Loading...
+ 3 hidden pages