Anritsu MU368060A User Manual

MU368060A
AWGN Unit
(For MG3681A Digital Modulation Signal Generator)
Supports IMT2000 System Receiver Test
The 3GPP and 3GPP2 recommended dynamic range test for W­CDMA and CDMA2000 receivers requires AWGN (Additive White Gaussian Noise) to be mixed on the wanted modulated signal. When the MU368060A AWGN Unit is installed in the MG3681A Digital Modulation Signal Generator, AWGN can be generated at real time. When both the MU368040A CDMA Modulation Unit that installed MX368041B W-CDMA Software is mounted, one MG3681A can be utilized as a wanted signal source (W-CDMA modulating), an inter­fering signal source (W-CDMA modulating, CW) and an AWGN source. Furthermore, since mixed Uplink W-CDMA signal and AWGN inter­nally can be outputted by setting the C/N in MX368041B, the base station receiver dynamic range test is realizable by one MG3681A. When both the MU368030A Universal Modulation Unit that installed MX368033A CDMA2000 1xEV-DO Signal Generation Software or MX368031A Device Test Signal Generation Software is mounted, one MG3681A can be utilized as a wanted signal source (CDMA2000 modulating), an interfering signal source (CDMA2000 modulating, CW) and an AWGN source. Furthermore, when both MU368040A CDMA Modulation unit are also mounted, since mixed CDMA2000 signal and AWGN internally can be outputted by setting the C/N in MX368033A or MX368031A, the base station receiver dynamic range test is realizable by one MG3681A.
Expansion units
Communication system Applicable software Expansion unit
W-CDMA (3GPP) —— CDMA2000
The expansion unit is installed in the MG3681A Digital Modulation Signal Generator mainframe.
Configuration of Communication System Software and Expansion Unit
2
MU368060A AWGN Unit
3GPP Recommended Dynamic Range and Interference Tests
Application Examples
This test does not require a separate signal generator for both interfering signal and AWGN.
W-CDMA wanted signal generator
MG3681A Digital Modulation Signal Generator MU368040A CDMA Modulation Unit MX368041B W-CDMA Software
MG3681A Digital Modulation Signal Generator MU368040A CDMA Modulation Unit MX368041B W-CDMA Software MU368060A AWGN Unit
Combiner (MA1612A, etc.)
Interfering signal (W-CDMA modulation)
Wanted signal (W-CDMA modulation)
Wanted signal (W-CDMA modulation)
Wanted signal (W-CDMA modulation)
AWGN
Interfering signal (CW)
DUT
(receiver, etc.)
Interfering signal and AWGN generator
Signal generator for wanted signal and AWGN
MG3681A Digital Modulation Signal Generator MU368040A CDMA Modulation Unit MX368041B W-CDMA Software MU368060A A WGN Unit
AWGN
Wanted signal (W-CDMA modulation)
DUT
(receiver, etc.)
Dynamic Range Test by mixed Uplink W-CDMA signal and AWGN internally
Since AWGN is mixed digitally, the C/N ratio accuracy and stability are excellent.
3
Model/Order No. Name
Main frame
MG3681A
1
Digital Modulation Signal Generator (250 kHz to 3000 MHz)
Expansion unit
MU368060A AWGN Unit
Standard accessory
W1955AE MU368060A operation manual: 1 copy
Maintenance service
MU368060A-90 Extended three year warranty service MU368060A-91 Extended five year warranty service
Model/Order No. Name
Expansion unit
MU368030A
1
Universal modulation Unit
MU368040A
1
CDMA Modulation Unit
Software
MX368031A
1
Device Test Signal Generation Software (for MU368030A)
MX368033A
1
CDMA2000 1xEV-DO Signal Generation Software (for MU368030A)
MX368041B
1
W-CDMA Software (for MU368040A)
Please specify the model/order number, name, and quantity when ordering.
Frequency range 100 to 3000 MHz RF output
Level range:–143 to –3 dBm (total power at W-CDMA and AWGN internal addition
1
)
Level accuracy:Within ±3.0 dB compared with CW output level.
1920 to 2170 MHz, noise bandwidth: 7.68 MHz, –3 dBm, ALC on, continuous mode: off
Probability distribution: Gaussian distribution Crest factor: 14 dB (1920 to 2170 MHz, –3 dBm, ALC on, continuous mode:off) Bandwidth: 1.5 to 16 MHz
2
Noise Calculated bandwidth: 10% to 80% of noise bandwidth setting
In-band power calculation accuracy (Accuracy of in-band calculated power ratio to total power of RF output) :
18° to 35°C ±0.6 dB (noise bandwidth setting: 1.5 to 4 MHz, typical) ±0.6 dB (1920 to 2170 MHz ,noise bandwidth setting: 4 to 8 MHz) ±2.0 dB (1920 to 2170 MHz ,noise bandwidth setting: 8 to 16 MHz)
C/N setting range
1
: –30.0 to –20.0 dB (resolution: 0.2 dB), –19.9 to – 8.0 dB (resolution: 0.1 dB)
1: AWGN internal addition function can be used only at uplink when the MU368040A and MX368041B are both installed in the MG3681A.2: Set a chip rate of x 1.5 or x 2 at AWGN internal addition
Specifications
Ordering Information
1: For details of the MG3681A, MU368030A, MU368040A, MX368031A,
MX368033A and MX368041B, refer to the relevant catalogs
ANRITSU CORPORATION
1800 Onna, Atsugi-shi, Kanagawa, 243-8555 Japan Phone: +81-46-223-1111 Fax: +81-46-296-1264
U.S.A. ANRITSU COMPANY North American Region Headquarters
1155 East Collins Blvd., Richardson, TX 75081, U.S.A. Toll Free: 1-800 - ANRITSU (267 - 4878) Phone: +1- 972-644-1777 Fax: +1-972-671-1877
Canada ANRITSU ELECTRONICS LTD.
700 Silver Seven Road, Suite 120, Kanata, ON K2V 1C3, Canada Phone: +1- 613 - 591 - 2003 Fax: +1-613-591-1006
Brasil ANRITSU ELETRÔNICA LTDA.
Praca Amadeu Amaral, 27 - 1 andar 01327-010 - Paraiso, Sao Paulo, Brazil Phone: +55-11-2283-2511 Fax: +55-21-2886940
U.K. ANRITSU LTD.
200 Capability Green, Luton, Bedfordshire LU1 3LU, U.K. Phone: +44- 1582 - 433280 Fax: +44-1582-731303
Germany
ANRITSU GmbH
Grafenberger Allee 54-56, 40237 Düsseldorf, Germany Phone: +49- 211 - 96855 - 0 Fax: +49-211-96855-55
France
ANRITSU S.A.
9, Avenue du Québec Z.A.de Courtabœuf 91951 Les Ulis Cedex, France Phone: +33-1-60-92-15- 50 Fax: +33-1-64-46-10-65
Italy
ANRITSU S.p.A.
Via Elio Vittorini, 129, 00144 Roma EUR, Italy Phone: +39- 06 - 509 - 9711 Fax: +39-06-502-24 - 25
Sweden
ANRITSU AB
Botvid Center, Fittja Backe 1-3 145 84 Stockholm, Sweden Phone: +46- 853470700 Fax: +46-853470730
Singapore
ANRITSU PTE LTD.
10, Hoe Chiang Road #07-01/02, Keppel Towers, Singapore 089315 Phone: +65- 6282 - 2400 Fax: +65- 6282 - 2533
Hong Kong
ANRITSU COMPANY LTD.
Suite 923, 9/F., Chinachem Golden Plaza, 77 Mody Road, Tsimshatsui East, Kowloon, Hong Kong, China Phone: +852-2301-4980 Fax: +852- 2301-3545
P. R. China ANRITSU COMPANY LTD. Beijing Representative Office
Room 1515, Beijing Fortune Building, No. 5 North Road, the East 3rd Ring Road, Chao-Yang Distr ict Beijing 100004, P.R. China Phone: +86-10-6590-9230
Korea ANRITSU CORPORATION
8F Hyun Juk Bldg. 832-41, Yeoksam-dong, Kangnam-ku, Seoul, 135-080, Korea Phone: +82-2-553-6603 Fax: +82- 2-553-6604
˜
5
Australia ANRITSU PTY LTD.
Unit 3/170 Forster Road Mt.Waverley, Victoria, 3149, Australia Phone: +61-3-9558-8177 Fax: +61- 3-9558-8255
Taiwan
ANRITSU COMPANY INC.
7F, No. 316, Sec. 1, NeiHu Rd., Taipei, Taiwan Phone: +886-2-8751-1816 Fax: +886- 2-8751-1817
Specifications are subject to change without notice.
Catalog No. MU368060A- E - A - 3 - (3.00) Pr inted in Japan 2003- 8 ddc/ddc
030617
Loading...