W A S H I N G M A C H I N E
T V Ä T T M A S K I N
P Y Y K I N P E S U K O N E
S T I R A L W N A Å M A fi I N A
INSTRUCTION BOOKLET
BRUKSANVISNING
KÄYTTÖOHJE
RUKOVODSTVO
PO ÈKSPLUATACII
E W N 1 0 3 0
E W N 1 2 2 0
E W N 1 2 2 0 A
|
GB |
|
S |
|
FIN |
132 988 290 |
RUS |
|
Dear customer,
Please read these operating instructions carefully and pay particular attention to the safety notes indicated in the first pages. We recommend that you keep this instruction booklet for future reference and pass it on to any future owners.
Transport damages
When unpacking the appliance, check that it is not damaged. If in doubt, do not use it and contact the Service Centre.
The symbols you will see on some paragraphs of this booklet have the following meaning:
The warning triangle and/or the key words (Warning!, Caution!) emphasize information that is particularly important for your safety or correct functioning of the appliance.
The information marked with this symbol provides additional instructions and practical tips on the use of the appliance.
Tips and information about economical and ecological use of the machine are marked with this symbol.
Our contribution to the protection of the environment: we use environmentally friendly paper.
Contents
Warnings |
3-4 |
Disposal |
4 |
Tips for environmental protection |
4 |
Technical specifications |
4 |
Installation |
5 |
Unpacking |
5 |
Positioning |
5 |
Water inlet |
5 |
Water drainage |
6 |
Electrical connection |
6 |
Your new washing machine |
7 |
Description of the appliance |
7 |
Door locked pilot light |
7 |
Detergent dispenser drawer |
7 |
Use |
8 |
Control panel |
8 |
Controls |
8-11 |
Washing hints |
12 |
Sorting the laundry |
12 |
Temperatures |
12 |
Before loading the laundry |
12 |
Maximum loads |
12 |
Laundry weights |
12 |
Removing stains |
12 |
Detergents and additives |
13 |
International wash code symbols |
14 |
Operating sequence |
15-17 |
Washing programmes |
18 |
Maintenance |
19 |
Door seal |
19 |
Bodywork |
19 |
Detergent dispenser drawer |
19 |
Drain pump |
19 |
Water inlet filter |
20 |
Emergency emptying out |
20 |
Frost precautions |
20 |
Something not working? |
21-22 |
2
Warnings
The following warnings are provided in the interests of overall safety. You must read them carefully before installing or using the appliance.
Installation
•All internal packing must be removed before using the appliance. Serious damage may be caused to the machine or adjacent furniture if the protective transit devices are not removed or are not completely removed. Refer to the relevant paragraph in the instruction book.
•Any electrical work required to install this appliance must be carried out by a qualified electrician.
•Any plumbing work required to install this appliance must be carried out by a qualified plumber.
•After having installed the machine, check that it is not standing on its electrical supply cable.
•If the appliance is placed on a carpeted floor, ensure that air can circulate freely between the feet and the floor.
General safety
•Repairs to the machine must be carried out only by qualified personnel. Repairs carried out by inexperienced persons could cause serious danger. Contact your local Service Centre.
•Never pull the power supply cable to remove the plug from the socket; always take hold of the plug itself.
•During high temperature wash programmes the door glass may get hot. Do not touch it!
Child safety
•Children are often not aware of how dangerous electrical appliances can be. When the machine is working, children should be carefully supervised and not be allowed to play with the appliance.
Use
•This appliance is designed for domestic use. It must not be used for purposes other than those for which it was designed.
•Only wash fabrics which are designed to be machine washed. Follow the instructions on each garment label.
•Do not overload the appliance. Follow the instructions in the instruction book.
•Make sure that all pockets are empty. Objects such as coins, safety pins, pins and screws can cause extensive damage.
•Do not machine wash garments saturated with petroleum, methylated spirits, trichlorethylene, etc. If such fluids have been used to remove stains prior to washing, wait until they have completely evaporated from the fabric before placing garments in the appliance.
•Place small items such as socks, belts, etc. in a cloth bag or pillowcase to prevent them getting trapped between the drum and the tub.
•Use only the recommended quantities of fabric softener. An excessive amount could damage the laundry.
•Leave the porthole door slightly ajar when the appliance is not in use. This preserves the door seal and prevents the formation of musty smells.
•Always check that water has emptied out before opening the door. If not, drain the water following the instructions in the instruction book.
•Always unplug the appliance and shut the water tap after use.
•The packaging components (e.g. plastic film, polystyrene) can be dangerous to children - danger of suffocation! Keep them out of children’s reach.
•Keep all detergents in a safe place out of children’s reach.
•Make sure that children or pets do not climb into the drum. To avoid this the machine incorporates a special feature. To activate this device, rotate the button (without pressing it) inside the door clockwise until the groove is horizontal. If necessary use a coin.
To disable this device and restore the possibility of closing the door, rotate the button anti-clockwise until the groove is vertical.
P1076 |
•When the appliance is to be scrapped, cut off the electrical supply cable and destroy the plug with the remaining cable. Disable the door catch in order to prevent children from becoming trapped inside while playing.
3
ENGLISH
Disposal
Packaging materials
The materials marked with the symbol 
are recyclable.
>PE<=polyethylene
>PS<=polystyrene
>PP<=polypropylene
This means that they can be recycled by disposing of them properly in appropriate collection containers.
Machine
Use authorised disposal sites for your old appliance. Help to keep your country tidy!
Tips for environmental protection
To save water, energy and to help protect the environment, we recommend that you follow these tips:
•Normally soiled laundry may be washed without prewashing in order to save detergent, water and time (the environment is protected too!).
•The machine works more economically if it is fully loaded.
•With adequate pre-treatment, stains and limited soiling can be removed; the laundry can then be washed at a lower temperature.
•Measure out detergent according to the water hardness, the degree of soiling and the quantity of laundry being washed.
Technical specifications
|
|
EWN 1030 |
EWN 1220 |
EWN 1220 A |
|||
DIMENSIONS |
Height |
85 cm |
85 cm |
85 cm |
|||
|
Width |
60 cm |
60 cm |
60 cm |
|||
|
Depth |
62 cm |
62 cm |
62 cm |
|||
|
|
|
|
|
|
|
|
MAXIMUM LOAD |
Cotton |
5 |
kg |
5 |
kg |
5 |
kg |
|
Synthetics |
2.5 kg |
2.5 kg |
2.5 kg |
|||
|
Delicates |
2.5 kg |
2.5 kg |
2.5 kg |
|||
|
Woollens/Hand wash |
2 |
kg |
2 |
kg |
2 |
kg |
SPIN SPEED |
|
1000 rpm max. |
1200 rpm max. |
1200 rpm max. |
|
|
|
||
POWER SUPPLY VOLTAGE/FREQUENCY |
220-230 V/50 Hz |
220-230 V/50 Hz 220-230 V/50 Hz |
||
TOTAL POWER ABSORBED |
|
2200 W |
2200 W |
2200 W |
MINIMUM FUSE PROTECTION |
|
10 A |
10 A |
10 A |
|
|
|
|
|
WATER PRESSURE |
Minimum |
500 kPa |
500 kPa |
500 kPa |
|
Maximum |
800 kPa |
800 kPa |
800 kPa |
This appliance complies with the following EEC Directives: 73/23/EEC of 19/02/73 relating to low voltage
89/336/EEC of 03/05/89 relating to electromagnetic compatibility.
4
Installation
Unpacking
All transit bolts and packing must be removed before using the appliance.
You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again.
Using a spanner unscrew and remove the two rear bottom screws. Slide out the two plastic pins.
Lay the machine gently on its back, making sure that the hoses are not squashed.
P1129 |
P0001 |
Remove the polystyrene block from the bottom of the machine and release the two plastic bags.
Very carefully slide out the left polythene bag, removing it towards the right and then downwards.
1 |
2 |
3 |
P1124 |
P1126 |
Repeat the operation for the right polythene bag, removing it towards the left and then upwards.
P1127 |
Remove the polystyrene base.
Set the machine upright and unscrew the remaining rear screw. Slide out the relevant pin.
Fill all the holes with the plastic plugs supplied with the instruction booklet.
P1128 |
P0002 |
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the machine does not touch the wall or other kitchen units.
Carefully level by screwing the adjustable feet in or out. Never place cardboard, wood or similar materials under the machine to compensate for any unevenness in the floor.
P1051 |
Water inlet
Connect the water inlet hose to a tap with a 3/4" thread.
The other end of the inlet hose which connects to the machine can be turned in any direction. Simply loosen the fitting, rotate the hose and retighten the fitting, making sure there are no water leaks
P1088 |
P0021 |
ENGLISH
5
The inlet hose must not be lengthened. If it is too short and you do not wish to move the tap, you will have to purchase a new, longer hose specially designed for this type of use.
Water drainage
The end of the drain hose can be positioned in three ways:
Hooked over the edge of a sink using the plastic hose guide supplied with the machine. In this case, make sure the end cannot come unhooked when the machine is emptying.
This could be done by tying it to the tap with a piece of string or attaching it to the wall.
P0022 |
In a sink drain pipe branch. This branch must be above the trap so that the bend is at least 60 cm above the ground.
Directly into a drain pipe at a height of not less than 60 cm and not more than 90 cm.
The end of the drain hose must always be ventilated, i.e. the inside diameter of the drain pipe must be larger than the outside diameter of the drain hose.
The drain hose must not be kinked. Run it along the floor; only the part near the drainage point must be raised.
P0023 |
Electrical connection
This machine is designed to operate on a 220-230 V, single-phase, 50 Hz supply.
Check that your domestic electrical installation can take the maximum load required (2.2 kW), also taking into account any other appliances in use.
Connect the machine to an earthed socket.
The manufacturer declines any responsibility for damage or injury through failure to comply with the above safety precaution.
Should the appliance power supply cable need to be replaced, this should be carried out by our Service Centre.
The power supply cable must be easily accessible after installing the machine.
6
Your new washing machine
This new washing machine, which is fitted with the Jet system, patented Electrolux, meets all modern needs for effective treatment of laundry with low water, energy and detergent consumption.
Further savings are achieved by washing small loads of laundry, since water and electricity consumption is proportional to the quantity and type of laundry being washed.
•The programme progress display shows the programme steps selected and the programme phase which is running.
•The special wool programme with its new delicate wash system treats your woollens with extreme care.
•Automatic cooling of the wash water to 60°C before draining, with the 95°C programme. This reduces thermal shock to fabrics, helping to prevent creasing.
•The balance control device ensures the machine is stable during the spin.
Description of the appliance
1 Detergent dispenser drawer
2 Control panel
3 Door locked pilot light
4 Drain pump
5 Adjustable feet
Door locked pilot light (3)
It stays on during the whole programme indicating that the door is locked.
When the light goes out, the door can be opened (see page 17).
1 |
2 |
95°C |
1000 |
60°C |
900 |
40°C |
700 |
30°C |
500 |
EWN 1220 |
|
3 |
|
|
4 |
5 |
|
Detergent dispenser drawer
Prewash
Main wash
Fabric softener, starch
C0063
ENGLISH
7
Loading...