3M™ D Sub EMI Junction Shell
Metalized Plastic
• Protection from EMI/ESD
• Easy assembly reduces time and labor to ensure low applied cost
• Light weight, compact design
• Strain relief compensates for multiple cable diameters
• Jackscrews provide positive retention
• RoHS* compliant
Date Modified: August 19, 2005 |
TS-0032-10 |
|
Sheet 1 of 2 |
Physical
Shell
Material: |
ABS |
|
Plating: |
Nickel Over Copper |
|
Compression Insert: |
|
|
Material: |
Thermo Plastic Elastomer |
|
Flammability: |
UL 94V-0 |
|
Durometer: |
75 + / - 5 |
|
Hardware: |
(2) |
Jackscrews #4-40 × .438 |
|
(2) |
Saddle Washers |
|
(2) |
Nuts 4-40 UNC for 9, 15 & 25 position |
|
(3) |
Nuts 4-40 UNC for 37 position |
(2)Screws 4-40 UNC for 9, 15 & 25 position
(3)Screws 4-40 UNC for the 37 position
Material: Steel Plating: Zinc
Mounting Hardware: See Specification Sheet TS-0142
Environmental
Temperature Rating: 0°C to +75°C
*RoHS = Directive 2002/95/EC, Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic Equipment "RoHS compliant" means that the product or part does not contain any of the following substances in excess of the following maximum concentration values in any homogeneous material, unless the substance is in an application that is exempt under RoHS: (a) 0.1% (by weight) for lead, mercury, hexavalent chromium, polybrominated biphenyls or prolybromianted diphenyl ethers; or (b) 0.01% (by weight) for cadmium. Unless otherwise stated by 3M in writing, this information represents 3M's knowledge and belief based upon information provided by third party suppliers to 3M.
3M
Interconnect Solutions http://www.3M.com/interconnects/
3M is a trademark of 3M Company. For technical, sales or ordering information call
800-225-5373