ZKM3013KN
ZKM 3013
Gebrauchs- und Einbauanweisung D
Glaskeramik-Kochfelder
Operating and assembly instructions GB
Glass ceramic hobs
Notice d'utilisation et de montage F
Plans de cuisson vitrocéramique
Istruzioni per l'uso e per il montaggio I
Piani di cottura in vetroceramica
Gebruiksaanwijzing en inbouwinstructies NL
Keramisch kookplateau
Brugs- og installationsanvisning DK
Glaskeramiske kogeplader
10
DEAR CUSTOMER
We congratulate you on choosing a ceramic hob of
Zanker. Thus you chose quality, innovation and durability.
These operating and assembly instructions will allow you
to become acquainted with the appliance and to do
everything within its possibilities.
11
CONTENT
Unpacking and control ........................................... 12
Preparation for installation ..................................... 12
Electrical connection ............................................. 13
Before the first use ................................................ 14
Description of appliances ...................................... 14
Operating instructions ........................................... 14
Cooking equipment ............................................... 15
Maintenance ......................................................... 16
Technical data ....................................................... 17
What to do in case of a defect............................... 17
12
UNPACKING AND CONTROL
PREPARATION FOR INSTALLATION
hob dimensions: 572 x 502 mm
cut out dimensions: 560 x 490 mm
fig. 1 sealing ceramic glass
worktable
bracket
Please examine the appliance for
any damage sustained during trans-
portation! If the appliance is dama-
ged please immediately inform the
forwarding company before the
appliance is connected. The pack-
ing material should be disposed
properly.
Cut out worktop to prescribed measurements or
templates (saw exactly along the scribing).
Check seal for perfect fit and overall cover.
Lower the ceramic hob into place and align correctly.
In terms of fire protection, the appliance conforms
to Type Y (IEC 335-2-6). Only appliances of this type
may be installed on one side of adjacent upright
furniture housings or walls.
Fastening according to Fig. 1
Fasten bracket against the underside of the worktop.
Using a standard or Phillips screwdriver, tighten the
tension clamps evenly starting at the centre and
moving diagonally, until the built-in rim is tight on the
worktop.
Do not overtighten!
Do not use an electric or pneumatic screw driver
without an adjustable safety clutch! (pos. 1 - 1.1 Nm)
55
560 –1
490 –1
R 5
1
2
Loading...