User's Manual
Ver. 130620
To ensure safe and easy installation,
please read the following precautions.
www.ZALMAN.com
FX100
AMD Socket FM2 / FM1 / AM3+ / AM3 / AM2+ / AM2 CPU&APUs
Intel Socket LGA 2011 / 1366 / 1156 / 1155 / 1150 / 775 CPUs
* Optional 92mm fan is required for Intel LGA 2011/1366 sockets.
1
.COM
2. Specifications
1. Precautions
1) Do not ingest the Thermal Grease, and avoid its contact with skin and eyes.
If contact is made with skin, wash off with water. If ingested or irritation
persists, seek medical attention.
2) To prevent possible injuries, gloves must be worn while handling this product.
3) Excessive force exerted on the fan may cause damage to the fan and/or
system.
4) Use and keep product away from reach of children.
5) Check the components list and condition of the product before installation.
If any problem is found, contact the retailer to obtain a replacement.
6) During transportation of the system, the cooler must be removed. Zalman
is not responsible for any damages that occur during the transport of a system.
7) Product design and specifications may be revised to improve quality and
performance.
FX100
Material Pure Aluminum & Copper
Weight 770g
Dimensions 156(L) x 156(W) x 157(H)mm
Noise Level 0dBA
Thermal
Grease
[ZM-STG2M]
Capacity 1g
Temperature
Range
-40°C ~ +150°C (-40℉ ~ +302℉)
Model
Spec.
Disclaimer) Zalman Tech Co., Ltd. is not responsible for any damages due to
external causes, including but not limited to, improper use, problems with
electrical power, accident, neglect, alteration, repair, improper installation,
or improper testing.
2
.COM
Nipple A
Fan Clip
Nuts
Thermal Grease
Bolts
Manual
Loading
Block
Intel Washer
(0.1mm)
AMD Washer
(1mm)
Double-sided
Tape
Backplate
Nipple B
Clip support
Cooler
Nuts & Side Caps
Installation Clip
3. Components
3
.COM
4. Installation Requirements
1) Space Requirments
2) Air Guide Removal
3) Cooler Orientation
The cooler’s installation requires an unobstructed space of 156mm(width),
156mm(length), and 157mm(height), with the CPU as a central reference
point. Please check if components such as ODDs and PSU protrude into the
required space.
Air guides on enclosures must be removed before the cooler’s installation
since they protrude into the cooler’s required space.
Mount the CPU cooler with the C-shaped heatpipe portion facing towards the
VGA card (as shown below).
※ There may be clearance issues with the graphics card if the CPU cooler is
improperly installed.
156㎜
Air Guide
Case Cover
157㎜
156㎜
Mother
Board
C-shaped
heatpipe
V
G
A
C
A
R
D
Loading...