Xerox DOCUPRINT N24, DOCUPRINT N32 User Manual

The Xerox
DocuPrint N24, N32, and N40
2,000 Sheet Finisher

Quick Installation/
Removal Guide

Before You Begin

If you are installing a printer at the same time as you are installing a finisher, install the
printer and 2,500 Sheet Feeder first, using the instructions that came with them. Then install
the finisher.

IMPORTANT: Installation of the finisher requires two people.

CAUTION: Use caution when moving the printer console and finisher to ensure that they
do not tip over.

CAUTION: Be careful of metal plate edges when installing the finisher.

To operate this finishing device, your DocuPrint N24, N32, or N40 must be at software

release 1.2 or higher. To verify your release , print a software configuration sheet from the
printer. If you do not have this release, you may obtain it from customer support or by
downloading it from: http://xerox.networkprinters.com/products/N40, or from
http://xerox.networkprinters.com/products/N32, or from
http://xerox.networkprinters.com/products/N24. Print Drivers and Finisher User
Documentation may also be obtained from these Web sites.

The finisher installation instructions are organized in the following sequence:

• Preparation and Unpacking

• Install the Transport Cover

• Install the Emissions Bracket Assembly

• Install the Guide Rail

• Install the Finisher

• Install the Staple Cartridge

• Complete the Installation

2 ❖ Xerox DocuPrint N24, N32, and N40 Finisher

Preparation and Unpacking

Power OFF the printer .

1

Disconnect the printer GFI power cord.

2

Unpack and remove the finisher from its

3

box according to the instructions on the
finisher box. Be sure to slide it off the
bottom of the box.

CAUTION: This operation should be
done by two people.

Remove any tape and packing material.

Save the carton and pac king materials

for later use in case you ever need to
ship the finisher back to Xerox.

Unpack the installation kit. You should

4

have these three items:
(1) Transport Cover and thumb screw
(2) Emissions Bracket Assembly and two

thumb screws
(3) Guide Rail with docking brackets.
(4) Staple Cartridge

Quick Installation/Removal Guide ❖ 3