Whirlpool AKP 983 NB, AKP 972 NB, AKP 987 NB, AKZ 358 NB, AKZ 367 NB User Manual

3gb66016.fm5 Page 1 Tuesday, April 16, 2002 3:27 PM

INSTRUCTION FOR USE

INSTALLATION

ELECTRICAL CONNECTION

BEFORE USING THE OVEN

HINTS FOR PROTECTING THE ENVIRONMENT PRECAUTIONS AND GENERAL SUGGESTIONS OVEN ACCESSORIES

CLEANING THE OVEN AND ITS ACCESSORIES TROUBLESHOOTING GUIDE

AFTER SALES SERVICE DECLARATION OF CONFORMITY CE

1

3gb66016.fm5 Page 2 Tuesday, April 16, 2002 3:27 PM

INSTALLATION

Technical information for the installer

•Unpack the oven to make the connections.

•Rest the oven on the polystyrene base to avoid damaging it.

•Do not lift the oven by the door handle, but hold it at the sides.

•Make sure that the appliance has not been damaged during transport.

•The dimensions of the oven and the unit are given in the picture below.

•Units in contact with the oven must be heat resistant (90°C).

•If plastic laminates or the sealing material are not sufficiently heat resistant, bubbles may form, the surface may be deformed or the coating may detach.

•House the oven in the unit cavity, lifting it at the sides and making sure that the supply cable is not trapped.

•To ensure correct ventilation, respect the ventilation openings indicated in the picture (200 mm2 minimum).

•Fasten the oven to the unit with the screws (A) as shown.

•The oven can also be fitted under a cooktop.

*: 590 For D+CH only

*

A

A

A

A

•There must be a gap of at least 5 mm between the upper edge of the oven and the lower edge of the working surface. This gap must never be closed by strips or unit reinforcing pieces. When the oven is installed, make sure that the sides do not touch the front edges of the unit or the adjacent drawers and door (see below picture).

No Contacts

2

3gb66016.fm5 Page 3 Tuesday, April 16, 2002 3:27 PM

ELECTRICAL CONNECTION

•Do not switch on the oven before connection is complete.

•Make sure that the installation and the electrical connection are made by a qualified engineer according to the manufacturer's instructions and the local rules in force.

•The installer is responsible for the correct electrical connection and for observance of the safety rules.

•The appliance must be connected to the main outlet by means of an omnipolar switching device with a contact opening distance of at least 3 mm.

•Grounding appliances is mandatory by law.

•Do not use multiple sockets or extensions.

•After the installation, the electrical parts must be inaccessible.

•Make sure that the voltage stated on the appliance rating plate is the same as the voltage in your home.

•The rating plate is on the front edge of the oven (visible when the door is open).

BEFORE USING THE OVEN

•For best use of the oven please read the instructions for use carefully and keep them in a safe place.

•Remove the cardboard protection and the protective plastic film.

•Take the accessories out of the oven and heat it to 200°C for about an hour to remove the smells and fumes of insulating material and protective greases. Keep the window open during this operation.

HINTS FOR PROTECTING THE ENVIRONMENT

1. Packing

• The packaging material is 100% recyclable and it is marked with the recycle symbol

( ).

2.Electrical appliances

•The electrical appliances are manufactured with recyclable or reusable material. Dispose of them following the local regulations for the disposal of waste. Before disposing of them make them unusable by cutting off the supply cable.

3