Viking VFLR4SS, VCF135SS, VBP18SS, VOCF135SS, VSP30SS Use & Care MANUAL

Use & Care

MANUAL

Outdoor Stainless Steel Cabinets

VBBO1601 / VBBO2602 / VURO3200 / VBO1811 / VBO1830 / VSBO2402 / VTOP1810

IMPORTANT - PLEASE READ AND FOLLOW

•Before beginning, please read these instructions completely and carefully.

•Do not remove permanently affixed labels, warnings, or plates from product. This may void the warranty.

•Outdoor stainless steel cabinets are not designed to be water tight. Water may enter cabinetry under certain conditions •The installer should leave instructions with the consumer who should retain for future reference

•NEVER use LP tanks inside any stainless steel cabinetry. Tanks must be located outside of the cabinetry at all times.

TO INSTALL CABINETS:

Illustration #1

1.Verify cabinet product number(s) on box(es) to list of cabinets ordered.

2.Carefully unpack cabinets making sure not to scratch fronts. Front panels are protected by plastic coating (that must be

removed after setup). Cabinets with interchangeable doors are shipped from the factory with opening from left to right as shown (See illustration #1).

3.In cabinets with interchangeable doors, hardware package will contain hole covers and hardware to install.

Illustration #2

4. Install 4 legs in the leg plates attached to bottom of each cabinet. Screw in place. (See illustration #2).

2

IMPORTANT - PLEASE READ AND FOLLOW!

5.Place cabinet(s) in approximate final position. Level cabinets using leveling legs. If installing two or more cabinets, use 1/2” SMS screws provided to screw them together. (See illustration #3).

Illustration #3

Install (4) Tinnerman clips (provided) before fastening cabinets together.

Mount cabinets with #10 x 1/2” (1.3 cm) screws provided.

6.On cabinets with interchangeable left or right hand swing, determine appropriate hinge side for cabinets. Remove outside door panel. Install hinges by placing hinge bracket in hole in door and fasten in place with hardware provided. Screw hole plate covers in appropriate predrilled holes in cabinet side. Fasten hole covers with hardware provided. (See Illustration #4).

7.Cabinet doors must be adjusted when cabinets are level in final position. There are two adjustment screws on the hinge receiver. (See Illustration #5)

•The front screw is used to center the door in the opening. Turning the front screws in or out will center the door over the cabinet opening. •The back screw is used to align the front of the

door with the cabinet frame and secure the door to the cabinet. Slightly loosen the screw and slide door in or out. Retighten the screw to secure the door.

Use #8 x 3/8” (.95 cm) flat head M.S. and locknut to attach hinge bracket to the inside door

Illustration #5

Use #8 x 3/8” (.95 cm) M.S. and locknut to fasten hole cover to inside door panel.

Back

Screw

Front

Screw

3