Viking VDR7364GBK, VGRT7364GSS, VGRT7486GSSLP, VGRT7366BSS, VDR7486GBK Installation

Installation Guide

Countertop Side Trim

Countertop Rear Trim

Installation (Side Trim)

For Models:

R24CSTSS - 24” D. VGIC Open Burner Ranges

1.Remove the outside grates and grate supports next to the counter.

2.Locate and remove the screws holding the grate support side trim in place. Keep the screws for reuse.

3.Lift the grate support side trim out. It will not be reinstalled.

4.Locate and remove the screws holding the heat shield in place. Keep the screws for reuse.

5.Lift the heat shield out and set aside for reuse.

6.Place the countertop side trim into place. Align with the countertop and the landing ledge. Replace and secure with the original screws.

7.Replace the heat shield and align the slotted screw holes with the screw holes in the side trim. Replace and secure with the original screws.

CAUTION

The heat shield must be replaced only if it is part of the original product.

8.This countertop side trim was designed to accommodate most installations. If the trim needs to be shorter, cut at the rear to fit.

Grate support side trim (standard with product)

Heat shield

(not on all products)

Countertop side trim (optional accessory)

Heat shield

(not on all products)

2

Installation (Side Trim)

For Models:

P24CSTSS - 24” D. 5 Series VGCC/VGSC/VDSC/VESC/VISC Ranges and VGRT Rangetops 24” D. RDSCG/RDSCD/RDSCE D3 Ranges

RD24CSTSS - 24” D. 3 Series RVGR/RVDR/RVER Ranges

Place the countertop side trim template against the side of the range or rangetop. The flange of the template should be wrapped around the back of the unit. The top of the template should be even with the top edge of the outer trim.

Mark the holes and remove template. Using a 9/64” drill bit, drill the three designated holes into the side of the range or rangetop. Place the countertop side trim into place and secure with the provided screws.

3