Ubiquiti UF-Nano operation manual
High-Performance GPON CPE
Model: UF-Nano
Introduction
Thank you for purchasing the Ubiquiti Networks® Nano™G
High-Performance GPON CPE. This Quick Start Guide is
designed to guide you through the installation and also
includes the warranty terms.
Package Contents
Nano G Wall Mount Bracket
Screws
(Qty. 4)
Gigabit PoE (24V, 0.3A)
with Mount Bracket
TERMS OF USE: All Ethernet cabling runs must use CAT5 (or above). It is the professional
installer’s responsibility to follow local country regulations, including operation within legal
frequency channels, output power, and indoor cabling requirements.
Screw Anchors
(Qty. 4)
High-Performance GPON CPE
Model: UF-Nano
Power Cord Quick Start
Guide
System Requirements
• Linux, MacOSX, or Microsoft Windows 7/8/10
• Web Browser: Google Chrome (Other browsers may have
limited functionality)
Hardware Overview
Ports
Port Description
PON SC/APC GPON port supports WAN connections of
2.488 Gbps downstream and 1.244 Gbps upstream.
RJ45 Ethernet port supports 10/100/1000 Mbps
connections and passive PoE to power the device.
Reset Press and release the Reset button to restore the
device to factory default settings.
LED Display
Power
GPON Ethernet
LED State Status
Green
Red
Flashing Red
GPON connected and device is
integrated into a network and
working properly
No GPON connection. Error code is
shown on the Digital Display.
Device is discovered by OLT and
waiting to be integrated
Off No power, device is off
White Power on, device is on
Off No Ethernet connection
Green Ethernet is connected
Flashing Ethernet activity
Digital
Display
Digital Display
The Digital Display shows device status and RX/TX details
of the PON connection. The Digital Display is also a physical
button. Press the display to cycle through the information.
• Mbps Displays the active download (RX) and upload ( TX)
speeds of the PON connection.
RX
TX
• dBm Displays the RX and TX power of the PON connection.
RX
TX
Note: If the GPON LED lights red, a malfunction or
error with the PON connection exists. Check and test
the fiber optic cable to ensure proper operation.
• GB Displays the total aggregate data sent downstream and
upstream through the PON connection. The counter can be
reset using the U Fiber Configuration Interface.
RX
TX
• IP Displays the PON (LAN) IP address.
• Time Only shown when the time is synced correctly from
the servers. Enable or disable the time display using the
U Fiber Configuration Interface.
*640-00254-05*
640-00254-05
Hardware Installation
The Nano G can be mounted on a wall or placed on a desktop.
WARNING: To reduce the risk of fire or electric shock, do
not expose the Nano G to rain or moisture.
Wall Mounting
1. Use the Wall Mount Bracket as a template and drill four
6mm holes as shown below.
40 mm
40 mm
2. Insert a Screw Anchor into each hole, and then fasten the
Wall Mount Bracket using four Screws.
3. Insert the top of the Nano G into the Mount Bracket and then
pivot the bottom into the bracket until it locks intoplace.
Loading...