LED Explanation
7106507099 REV5.1.1
Installation Guide
8-Port 10/100Mbps Desktop Switch with 4-Port PoE
TL-SF1008P
Connection
1. Application
PoE MAX
On: 50W ≤ Total power supply < 57W
Flashing: Total power supply = 57W
O: Total power supply < 50W
PoE Status (port 1-4)
On: PoE power provided
Flashing: PoE fault
O: No PoE power provided
PoE MAX
PoE Status
Power
On: Power on
O: Power o
Link/Act (port 1-8)
On: Link present but no activity
Flashing: Transmitting/receiving data
O: No link
Power
Link/Act
Ethernet Ports (1-8)
Internet
Note:
PoE ports can also connect to non-PoE devices,
1.
but only transmit data.
Maximum PoE power is 15.4W for each PoE port
2.
and 57W for all PoE ports.
PC
PoE Devices
IP Camera AP
PoE Ports (1-4)
IP Phone
2. Plug and Play
1
AC Power CordDC Power Adapter
2
3
Frequently Asked Questions (FAQ)
Specications
Q1. The Power LED is not lit.
The Power LED should be lit when the power system is working normally. If the
Power LED is not lit, please check as follows:
A1:
Make sure the AC power cord is connected the switch with power source
properly.
A2:
Make sure the voltage of the power supply meets the requirements of the
input voltage of the switch.
A3:
Make sure the power source is on.
Q2. The Link/Act LED is not lit when a device is connected to the
corresponding port.
It is recommended that you check the following items:
A1:
Make sure that the cable connectors are rmly plugged into the switch and
the device.
A2:
Make sure the connected device is turned on and working well.
A3:
The cable must be less than 100 meters long (328 feet).
General Specications
Standard
Protocol
Interface
Network Media (Cable)
PoE Ports (RJ45)
Backbone Bandwidth
MAC Address Table
Transfer Method
Power Supply
Consumption
Fan Quantity
IEEE802.3i, 802.3u, 802.3x, 802.3af
CSMA/CD
8 10/100Mbps RJ45 Ports
Auto-Negotiation/Auto MDI/MDIX
10BASE-T: UTP category 3, 4, 5 cable
(maximum 100m)
EIA/TIA-568 100
Ω
STP (maximum 100m)
100BASE-TX: UTP category 5, 5e cable
(maximum 100m)
EIA/TIA-568 100
Ω
STP (maximum 100m)
PoE Ports: Port1- Port4
Total Power Supply: 57W
1.6Gbps
2K
Store-and-Forward
External Power Adapter
(Input 100-240VAC, 50/60Hz
Output: 48VDC /1.25A)
2.3 watts (max. no PoE device connected)
59.3 watts (max. with 57w PoE device connected)
Fanless
Q3. Why is port 4 not supplying power for PoE devices?
If connected PoE device’s total power consumption exceeds 57W, the system
will cut o the power to port 4. For example, port 1, 2 and 4 are consuming 15.4W
respectively, if an additional PoE device with 12W is inserted to port 3, the system
will cut o the power of port 4 to compensate for the overload.
For technical support and other information, please visit
http://www.tp-link.com/support
FCC STATEMENT
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference that may cause undesired
operation.
Any changes or modications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
この装置は、クラスA情報技術装置です。この装置を家庭環境で使用すると電波妨害を引き起こすことがあり
ます。この場合には使用者が適切な対策を講ずるよう要求されることがあります。 VCCI-A
SAFETY NOTICES
Cautions
Do not use this product near water, for example, in a wet basement or near a swimming pool.
Avoid using this product during an electrical storm. There may be a remote risk of electric shock from
lightning.
Environmental and Physical Specications
Certication
Operating Temperature
Storage Temperature
Operating Humidity
Storage Humidity
CE Mark Warning
This is a class A product. In a domestic environment, this product may cause radio interference, in which
case the user may be required to take adequate measures.
Продукт сертифіковано згідно с правилами системи УкрСЕПРО на відповідність вимогам
нормативних документів та вимогам, що передбачені чинними законодавчими актами України.
Explanation of the symbols on the product label
DC voltage
RECYCLING
This product bears the selective sorting symbol for Waste electrical and electronic equipment
(WEEE). This means that this product must be handled pursuant to European directive
2012/19/EU in order to be recycled or dismantled to minimize its impact on the environment.
User has the choice to give his product to a competent recycling organization or to the retailer
when he buys a new electrical or electronic equipment
Indoor use only
FCC, CE, RoHS
0˚C to 40˚C (32˚F to 104˚F)
-40˚C to 70˚C (-40˚F to 158˚F)
10% to 90% non-condensing
5% to 90% non-condensing
© 2017 TP-Link