XE-A206
XE-A206 Quick Start Guide
REG
OPX/Z MGR
PGM
X1/Z1
X2/Z2
OFF
VOID
Print roller arm
Print roller release lever
r
r
Paper positioning
guides
The following describes how to get the cash register ready for operate. Follow these steps before you use the cash register for the first time.
Before you set up the cash register, prepare three new alkaline batteries LR6 ("AA" size) which are necessary for memory backup. Find a stable and flat surface not subject to direct radiation, to place
the cash register.
English
1
To ensure the cash register operates properly, please use the following
procedure:
1. Make sure the power cord is unplugged and batteries are not
2. Insert the manager (MA) key into the mode switch and turn it to the
3. Insert the plug of the power cord into the AC outlet. The buzzer will
IMPORTANT: This operation must be performed without batteries installed.
4. The cash register has now been initialized.
2
Initializing the Cash Register
installed on the register.
REG position.
sound three times.
The register display will show “0.00” with “ ”.
Installing the Batteries
3
If you want to use a paper roll for journal printing, please refer to GETTING
STARTED section of the instruction manual.
MA
1. Lift up the print roller release lever to unlock and open the print roller arm.
2. Set a paper roll in the paper roll cradle as illustrated right.
NOTE: When setting a new paper roll in the paper roll cradle, be sure to cut
3. Feed the end of the paper along with the paper positioning guides
Installing the Paper Roll
the paper end behind the taped (or pasted) point in advance.
as illustrated at the right.
(for receipt printing)
To the printe
Correct
To the printe
Incorrect
1. Push the printer cover forward and detach it.
2. Open the battery compartment cover next to the paper roll cradle.
3. Install three new alkaline batteries LR6 (“AA” size) as shown at the
4. When the batteries are properly installed, “ ” on the display will
right. (Batteries are not supplied with the cash register.) Make sure
that positive (+) and negative (–) poles of each battery are properly
oriented.
disappear. Close the battery compartment cover.
4. While holding down the paper, slowly close the print roller arm, and
push down the arm until you hear a click locking the arm.
Make sure you securely push down the center of the wing part of the
arm as illustrated at the right. The paper will be fed automatically.
5. Cut off the excess paper using the edge of the inner cover, and
replace the printer cover. Press the
end comes out of the printer cover and clean paper appears.
NOTE: If the print roller arm is not securely locked, the unit will not print correctly.
If this problem occurs, open the arm, and close the arm as instructed
above.
key to make sure the paper
F
Loading...