Commercial Professional
C |
D E F |
G |
H |
I |
|
B |
|
|
|
|
|
A |
|
|
|
|
|
|
|
|
|
Made in Germany |
|
|
L |
K |
|
J |
|
■ Description: |
|
|
|
|
|
AWater filling inlet
BSpray nozzle
CBurst of steam button
DSpray button
EVariable steam control / Self clean
FIndicator light
GTemperature control dial
HSwivelling cord protector
ISupply cord
JTransparent water tank
KStainless steel soleplate
LWater level indicator
Rowenta Werke GmbH 63016 Offenbach am Main
IMPORTANT SAFEGUARDS
When using your iron, basic safety precautions should always be followed, including the following:
Read all instructions before using the iron.
1.Use iron only for its intended use.
2.To protect against a risk of electric shock, do not immerse the iron in water or other liquids.
3.The iron should always be turned to Minimum (Min) before plugging or unplugging from outlet. Never yank cord to disconnect from outlet, instead grasp plug and pull to disconnect.
4.Do not allow cord to touch hot surfaces. Let iron cool completely before putting away. Loop cord loosely around iron when storing.
5.Always disconnect iron from electrical outlet when filling iron with water, emptying iron or when not in use.
6.Do not operate iron with a damaged cord or if the iron has been dropped or damaged. To avoid the risk of electric shock, do not disassemble the iron, take it to the nearest authorized Rowenta Appliance Service Center for examination and repair. Incorrect reassembly can cause a risk of electric shock when the iron is used.
7.Close supervision is necessary for any appliance being used by or near children. Do not leave iron unattended while connected or on an ironing board.
8.Burns can occur from touching hot metal parts, hot water or steam. Use caution when you turn a steam iron upside down – there may be hot water in the reservoir.
9.The use of accessory attachments is not recommended by Rowenta Appliance Company and may result in fire, electric shock or personal injury.
SPECIAL INSTRUCTIONS
1.This is a 1400 watt appliance. To avoid a circuit overload, do not operate another high wattage appliance on the same circuit.
2.If an extension cord is absolutely necessary, a 12-ampere cord should be used. Cords rated for less amperage may overheat. Care should be taken to arrange the cord so that it can not be pulled or tripped over.
3.After the iron has cooled, wrap the cord loosely around the handle.
SAVE THESE INSTRUCTIONS
BEFORE USE
MPlease read the instructions for use and the Important Safeguards carefully.
MSlowly peel the protective cover off the soleplate.
MIt is normal for a small amount of smoke to be produced the first time the iron is used. This will quickly disappear.
3-WAY AUTO-OFF
BEFORE USE:
To enable the appliance to heat up properly when first used, the electronic auto-off does not react till 2 minutes after the appliance has been plugged in.
30 sec.
8 min.
30 sec.
MIf the iron is not moved while it is switched on, an internal safety switch will turn it off.
It will turn off in 8 minutes if left vertically or in 30 seconds if left on its soleplate or tipped over.
MA red flashing light indicates that the auto-off has been activated. To switch the iron on again, move the iron or gently shake it.
Wait until iron is fully reheated before use.
STEAM IRONING
Filling with water
M Ensure the iron is unplugged. M Slide the variable steam control
completely to the left.
M Hold the appliance upright so that the water filling inlet is horizontal.
M Fill the iron with tap water to the maximum level mark (see water usage for more information).
Adding water
MIf you need to add water during ironing, unplug the iron and repeat above steps.
MEnsure iron is fully reheated after filling (temperature indicator light goes out) before ironing.
SELECTING THE TEMPERATURE
m |
i |
n |
To avoid damage to clothes from dust or dirt that may collect in the iron, we recommend that for the first use or after the iron has been stored for some time that you first iron an old cloth, testing both the steam and burst of steam feature.
Set the temperature control dial according to the type of fabric you are ironing. Check the fabric's label for appropiate setting.