Orion 19RCR, 17RCR User Manual

Installation and User's Guide

RACK MOUNT READY SERIES

(17~19 inches)

http://www.orionimages.com

All contents of this document may change without prior notice, and actual product appearance may differ from that depicted herein

http://www.orionimages.com

Installation and User's Guide

1. SAFETY INSTRUCTION

Follow this safety instruction to use the monitor properly and prevent the damages.

This safety instruction has “Warning” & “Caution” as below

Warning - If the user does not follow this instruction,

it may cause the serious damage to the user.

Caution - If the user does not follow this instruction, it may cause the slight damage to the user or cause some damages to the monitor.

Keep this user’s guide book for later use.

Warning

Never remove the back over and	Keep away the monitor from the
touch the inside of the monitor.	direct sunlight and a heating appliance.
If you need a service, please
contact the service center.

Never push objects of any kind into this product as they may result in a risk of fire or electric shock.

Connect the power code to the wall outlet tightly. If the power code or plug are defective and the wall outlet is not tight, please do not use them.

	7300 Bolsa Avenue, Westminster CA 92683	2
	Tel : [phone] / Fax : [phone] / [e-mail]

http://www.orionimages.com

Installation and User's Guide

Warning

Do not install this monitor on the outside and near water. If may cause damage to the product, electric shock and fire.

For cleaning do not use liquid cleaners. Never touch the power plug with wet-hands.

When lightning and thundering, unplug the monitor from the wall outlet and never touch it.

Unplug this product from the wall outlet, when It does not operate for a long time.

When smoking and noising from the monitor, unplug the product from the wall outlet and contact a service center.

WARNING : How to fix

Do not open this product as it contains high voltage inside. It may create an electric shock.

It the user disassembles and remove the back cover, it does not make sure to make up for the damages and do a service and exchange the monitor.

	7300 Bolsa Avenue, Westminster CA 92683	3
	Tel : [phone] / Fax : [phone] / [e-mail]

http://www.orionimages.com

Installation and User's Guide

Cautions

Install this monitor some distance From the wall and do not install unless Proper ventilation is provided.

The openings must not be blocked by curtain, rug or other similar surface.

Before carrying the monitor, tum it off and Unplug the signal cables and the power code From the wall outlet.

Place this product on a stable place. If not, it may fall, causing serious Damages to the monitor and people.

When carrying this monitor, be careful not to damage the panel and drop it It may cause some trouble.

Take the power plug out from the wall outlet.

Do not pull the cable. It may snap the innerwires and cause overheating and fire.

	7300 Bolsa Avenue, Westminster CA 92683	4
	Tel : [phone] / Fax : [phone] / [e-mail]

http://www.orionimages.com

Installation and User's Guide

Cautions

Install this monitor about 50cm far from the eyes and an angle of 0~15 degrees below eyes. Too close installation may cause having weak sight.

For cleaning, unplug the monitor from the Wall outlet. Do net use the liquid cloth. Use the soft cloth.

Do not press the LCD panel with hands or the sharpened material hardly.

Do not use the chemical liquid for cleaning. It may cause fading and breakage.

	7300 Bolsa Avenue, Westminster CA 92683	5
	Tel : [phone] / Fax : [phone] / [e-mail]

http://www.orionimages.com

Installation and User's Guide

2. FCC RF INTERFERENCE STATEMENT

NOTE

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures.

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio, TV technician for help. Only shielded interface cable should be used.

Finally, any changes or modifications to the equipment by the user not expressly approved by the grantee or manufacturer could void the users authority to operate such equipment.

DOC COMPLIANCE NOTICE

This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out in the radio interference regulation of Canadian Department of communications.

	7300 Bolsa Avenue, Westminster CA 92683	6
	Tel : [phone] / Fax : [phone] / [e-mail]

http://www.orionimages.com

Installation and User's Guide

TABLE OF CONTENTS

1. SAFETY INSTRUCTION													2
1-1 Warning
1-2 Caution
2. FCC STATEMENT													6
3. INSTALLATION													8
3-1 Parts
3-2	How to Install
4. OSD MENU SETTING													12
5-1	Mode Setting
5-2	Menu Setting (VIDEO, S-VIDEO, HDMI Mode)
5-3	Menu Setting (VGA Mode)
5. FEATURES													26
6. LIMITED WARRANTY															27
7. TROUBLESHOOTING														27

	7300 Bolsa Avenue, Westminster CA 92683	7
	Tel : [phone] / Fax : [phone] / [e-mail]

http://www.orionimages.com		Installation and User's Guide
3. INSTALLATION
3-1 Parts
	LCD Monitor
Adapter	VGA Cable	Power Cable
* Adapter is attached to the back of product
Battery	Remote Controller	User Manual
	7300 Bolsa Avenue, Westminster CA 92683		8
	Tel : [phone] / Fax : [phone] / [e-mail]

http://www.orionimages.com

Installation and User's Guide

3-2 How to Install

KEY BUTTON

SHORT KEY FUNCTION

	OSD Key		Function
			Activates and exit the OSD
			Select input source, and select the OSD menu
			Move the OSD menu and auto adjustment of RGB source
			Decrease the level of volume and move the previous menu
			Increase the level of volume and select rhe OSD menu
			Turns the power ON or OFF. There will be a few seconds
			delay before the display appears.The power LED (next to the
			power switch) lights with green when the power is turned ON.
			The power is turned off by pressing the power switch again
			and the power LED goes red.

	7300 Bolsa Avenue, Westminster CA 92683	9
	Tel : [phone] / Fax : [phone] / [e-mail]