Mindray iMEC, iMEC 8, iMEC 10, iMEC 12 Quick Manual
iMEC Series
Patient Monitor
Quick Guide
© 2011 Shenzhen Mindray Bio-Medical Electronics Co., Ltd. All rights reserved.
Content in this guide is subject to change without prior notice.
Thank you for purchasing Mindray Patient Monitor.
We have included this convenient Quick Guide to help you with the basic operations. For
more details , please refer to the Operator’s Manual.
Note:
Before attempting to install, operate or adjust this product, please save and read the
Quick Guide completely.
This manual is based on the maximum conguration and therefore some contents may
not apply to your monitor. If you have any question, please contact us.
0123
Com ply with the re qui r eme nts of the
Council Directive 93/42/EEC.
1
Product Overview
Front View
1. Power On/Off Switch
Press the switch to turn on the patient monitor. When the monitor is
on, pressing and holding this switch turns the patient monitor off. An
indicator is built in this switch. It turns on when the patient monitor is
on and turns off when the patient monitor is off.
2. AC power LED
It turns on when AC power is connected.
3. Battery LED
On: when the battery is installed and the AC source is connected.
Off: when no battery is installed or the installed battery is malfunction,
or no AC source is connected when the patient monitor is power
off.
Flash: when the patient monitor operates on battery power.
4. Alarm lamp
When a physiological alarm or technical alarm occurs, this lamp will
ash as dened below.
the lamp quickly ashes red.
the lamp slowly ashes yellow.
the lamp lights yellow without ashing.
5. Display Screen
6. Press to silence all alarm sounds.
7. Press to pause or restore alarms.
8. Press to freeze or unfreeze waveforms.
9. Knob
10. If no menu is displayed on the screen, pressing it enters the
main menu.
If there is a menu displayed on the screen, pressing it closes that
menu.
11. Press to start or stop recordings.
12. Press to start or stop NIBP measurements.
High level alarms:
Meidum level alarms:
Low level alarms:
6
7
8
9
10
11
12
1
2
3
5
4
2
Product Overview
Side View (iMEC 12/iMEC 10)
3
1
2
1
2
1. Recorder
2. Battery compartment
3. Connectors for parameters
Side View (iMEC 8)
3
Product Overview
Rear View (iMEC8)Rear View (iMEC 12/iMEC 10)
1
1
2
2
43
5 6
1. Equipotential Grounding Terminal
2. AC Power Input
3. Multifunctional Connector
4. USB Connector
5. VGA Connector
6. Network Connector
Loading...