Miele CVA 4060 Operating instructions

Short instructions
CVA 40xx
These short instructions are not a substitute for the Operating Instruction booklet supplied with your coffee machine.
Please read the Operating Instruction booklet supplied with your machine before using it for the first time and take note of the Warning and Safety instructions as well as the full descriptions on how to use your machine.
M.-Nr. 06 919 250
Tips on making drinks
2 coffees or 2 espressos
CVA 4060: Press the right-hand control knob twice in quick succession.
^
CVA 408x: Touch the sensor pad next to "2 portions".
To interrupt making coffee or espresso
To interrupt preparation press the right-hand control knob (CVA 4060) or press
^
the "+ C" sensor pad (CVA 408x).
Cappuccino
Place a jug of
^
milk underneath the suction tube.
Setting the portion size for coffee, espresso and milk froth for cappuccino
Select the type of drink required.
CVA 4060:
^ Press and hold the right-hand control
knob until "Programme the amount" appears in the display.
^ Release the control knob and then
press it again when there is sufficient liquid in the cup.
Place a cappuc
^
cino cup under neath the cappuccinatore spout.
CVA 408x:
^ Press the sensor pad until
"Programme the amount" appears in the display.
^ Release the touch sensor next to "ok"
and then press it again when there is sufficient in the cup.
Select "Cappuc
-
^
cino" and follow
­the instructions given in the display.
-
Setting the amount of espresso required for a cappuccino
^
When prompted, place a cup underneath the coffee spout. Then press the right-hand control knob or the sensor pad next to "Cappuccino" until "Programme the amount" appears in the display.
Making coffee with ready-ground coffee
^
^
Open the front of the coffee machine.
^
Pull out the ground coffee container (top left).
Open the cover to the ground coffee a.
^
Place 1 level spoon of ground coffee in the chute b and then close it.
^
Follow the instructions in the display.
Important care tips
a
a
All parts, except the brew unit and the coffee bean container, are dishwasher safe.
Before use:
It is very important to programme the water hardness level into the machine to
^
prevent limescale building up too quickly. See "Setting the water hardness" section in the Operating Instruction booklet.
Regular maintenance:
Follow all maintenance instructions that appear in the display.
^
The following must also be cleaned on a regular basis:
All parts of the drip
The machine door
^
- follow the "Cleaning and care" instructions in the Operating Instruction booklet carefully.
^
tray should be cleaned in the dishwasher, including the black grille inside the machine.
^ Wipe the small
drip tray inside the door.
^ Clean the
surface and channel under­neath the water container (bottom right).
^
Using a damp cloth wipe the inside of the ma chine. A vacuum cleaner can be used on dried coffee grounds.
Display message "Please run cleaning programme" (= degrease the brew unit)
^
Open the cover to the ground coffee chute.
^
Clean the bean container (top
-
right) with a solution of hot water and washing-up liquid.
^
The connection in the door between the brew unit and the coffee outlet should be wiped clean with a damp cloth. The seal should be lubricated once a month with the grease supplied.
^
Place a cleaning tablet in the chute. Close the cover and follow the instructions in the display.
Clean the brew unit
Press button a
^
under the handle and turn handle to the left b.
Press brew unit
^
catch c down wards and pull
Remove all the
^
the brew unit out.
drawers.
Cleaning the cappuccinatore
-
Rinse residues off the steel filter in the
^
brew unit using your fingers, and pat dry with a tea towel.
After cleaning
^
lubricate the seals.
^ Turn cover a
above the spout to the left.
^ Carefully pull the
spout and suction tube downwards b.
^ Dismantle the
parts. Dismantle the part with the seal by twisting and pulling apart. Clear holes by blowing.
^ When replacing
the cappuccina­tore, make sure that it is locked in place with the lugs facing downwards.
Descaling the machine (approx. 20 mins) Important: Only use the descaling tablets supplied with the machine. The
descaling funnels must be used to prevent the front of the machine being splashed and damaged by descaling agent.
^
^
Fill the water con tainer to the k mark with luke warm water and thoroughly dissolve 2
descaling tablets in it.
^
-
Place the descaling funnels under the spouts.
Follow the instructions in the display.
01 / 0207
Loading...