Maytag MFT2771WEB, MFT2771WEM, MFT2771WEW, MFT2771XEB, MFT2771XEM Dimension Guide

		Bottom Mount Refrigerator
	PRODUCT MODEL NUMBER		PRODUCT DIMENSIONS
	MFT2771WE	MFT2771XE
	Electrical: A 115-volt, 60-Hz, AC-only, 15or		H
	20-amp fused, grounded electrical supply is
	required. It is recommended that a separate		G
	circuit serving only your refrigerator be
			cabinet
	provided. Use an outlet that cannot be turned				I
	off by a switch. Do not use an extension		F		C
	cord.		not incl.
	NOTE: Before performing any type of		handle
	installation, cleaning, or removing a light		E	90˚	90˚
	bulb, turn the control (Thermostat,
			incl.	A
	Refrigerator or Freezer Control depending on			overall
			handle
	the model) to OFF and then disconnect the
			B
	refrigerator from the electrical source. When
			top of
	you are finished, reconnect the refrigerator to		cabinet
	the electrical source and reset the control
	(Thermostat, Refrigerator or Freezer Control
	depending on the model) to the desired
	setting. See “Using the Controls.”

Water: A cold water supply with water

pressure between 30 and 120 psi (207 and

827 kPa) is required to operate ice maker

D

and water dispenser. If you have questions

about your water pressure, call a licensed,

qualified plumber.

IMPORTANT: The pressure of the water

coming out of a reverse osmosis system

going to the water inlet valve of the

refrigerator needs to be between 30 and

Height -

Depth -

Depth -

Depth -

Depth -

Depth -

Width -

120 psi (207 and 827 kPa).

Height -

Top of

Doors

Drawer

With

Without

Cabinet

Width -

Door Open

Reverse Osmosis Water Supply: If a

Overall

Cabinet

Open 90°

Open

Handles

Handles

Only

Cabinet

90°

Model Size

“A”

“B”

“C”

“D”

“E”

“F”

“G”

“H”

“I”

reverse osmosis water filtration system is

537⁄8"

327⁄8"

355⁄8"

391⁄4"

connected to your cold water supply, the

26.6 cu.ft.

701⁄8"

689⁄16"

477⁄8"

351⁄4"

291⁄16"

water pressure to the reverse osmosis

(178.1 cm)

(174.14 cm)

(121.6 cm)

(136.8 cm)

(89.54 cm)

(83.5 cm)

(73.8 cm)

(90.5 cm)

(99.7 cm)

system needs to be a minimum of 40 to

60 psi (276 to 414 kPa).

LOCATION REQUIREMENTS

To ensure proper ventilation for your refrigerator, allow for a 1⁄2" (1.25 cm) space on each side and at the top. Allow for 1" (2.54 cm) of space behind the refrigerator. If your refrigerator has an ice maker, make sure you leave some extra space at the back for the water line connections.

		¹⁄ " (1.25 cm)		If you are installing your refrigerator next to a fixed wall, leave 33⁄4" (9.5 cm)
				minimum on the hinge side (depending on your model) to allow for the door to
				swing open.

NOTE: It is recommended that you do not install the refrigerator near an oven, radiator, or other heat source, nor in a location where the temperature will fall below 55°F (13°C).

3³⁄ " (9.5 cm)

Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice.

Dimensions are for planning purposes only. For complete details, see Installation	Ref. W10252999A
Instructions packed with product. Specifications subject to change without notice.	3/02/11