REFRIGERATORFREEZER
OWNER'S MANUAL
PLEASE
READ THIS OWNER'S MANUAL THOROUGHLY BEFORE OPERATING AND KEEP IT HANDY FOR REFERENCE AT ALL TIMES.
LODîWKA-
ZAMRAûARKA
INSTRUKCJA UûYTKOWNIKA
PRZED URUCHOMIENIEM ZESTAWU PROSIMY DOKüADNIE ZAPOZNAŒ SI¢ Z NINIEJSZ„ INSTRUKCJ„. I ZACHOWAŒ
J„ DO WYKORZYSTANIA W PRZYSZÖüOåCI.
P/No. 3828JP8011V
CONTENTS
INSTALLATION ............................................ |
3 |
FEATURE CHART ........................................ |
4 |
OPERATION .................................................. |
5 |
Starting |
|
Temperature Control |
|
Ice Making |
|
Chilled Compartment |
|
Defrosting |
|
Deodorizer (Optional) |
|
SUGGESTIONS ON FOOD STORAGE ...... |
8 |
REVERSIBLE DOOR ................................... |
9 |
Precaution |
|
How to reverse the door |
|
CLEANING .................................................. |
11 |
GENERAL INFORMATION ....................... |
11 |
LAMP REPLACEMENT ............................. |
12 |
IMPORTANT WARNINGS ......................... |
12 |
BEFORE CALLING FOR SERVICE ......... |
13 |
SPECIFICATIONS ...................................... |
14 |
2
THIS REFRIGERATOR IS MANUFACTURED WITH GREAT CARE AND UTILIZES THE LATEST IN TECHNOLOGY.
WE ARE CONFIDENT THAT YOU WILL BE FULLY SATISFIED WITH ITS PERFORMANCE AND RELIABILITY.
BEFORE USING YOUR REFRIGERATOR, PLEASE READ THIS BOOKLET CAREFULLY.
IT PROVIDES EXACT INSTRUCTIONS FOR INSTALLATION, OPERATION, AND MAINTENANCE, AND ALSO SUPPLIES SOME USEFUL HINTS.
INSTALLATION
SELECT A GOOD LOCATION
1.Place your refrigerator where it is easy to use.
2.Avoid placing the refrigerator near heat sources, direct sunlight or moisture.
3.Air must circulate properly around your refrigerator to ensure efficient operation.
If your refrigerator is placed in a recessed area in the wall, allow at least 10 inches (25 cm) or greater clearance above the refrigerator and 2 inches (5 cm) or more from the wall.
The refrigerator should be elevated 1 inch (2.5 cm) from the floor, especially if the floor is carpeted.
4.To avoid vibrations, the refrigerator must be level. If necessary, adjust the leveling screw(s) to compensate for unevenness of the floor.
To close the doors easily, the front should be slightly higher than the rear. Leveling screw(s) can be turned easily by tipping the cabinet slightly. Turn the leveling screw(s) clockwise to raise the refrigerator, counterclockwise to lower it.
NEXT
1.Wipe off all dust accumulated during shipping and clean your refrigerator thoroughly.
2.Install accessories such as the ice cube box, evaporating tray cover, etc., in their proper places. They are packed together to prevent possible damage during shipping.
3.Connect the power supply cord (or plug) to the outlet. Don't double up with other appliances on the same outlet.
4.Prior to use, let the refrigerator run for 2-3 hours. Check the flow of cold air in the freezer compartment to ensure proper cooling has taken place.Your refrigerator is now ready for use.
3
FEATURE CHART
FREEZER
COMPARTMENT
Twisting Ice Serve (Optional)
or General Type Ice Making
Freezer Temperature
Control Knob
Cap Hinge
(Optional)
REFRIGERATOR
COMPARTMENT
Chilled Compartment
Refrigerator Temperature
Electronic Control
Lamp
Deodorizer
(Optional)
Vitamin Kit
(Optional)
Vegetable Drawer 
Used to keep fruits
and vegetables, etc. fresh and crisp.
Cap Cover
(Optional)
Upper Hinge
Freezer Door Rack
Egg Storage Rack
(GN-292,GR-292 only)
Refrigerator Door Rack
Leveling Screws
|
TE |
O |
|
N |
|
All parts shown may not be included with every model.
4
OPERATION
STARTING
When your refrigerator is first installed, allow it 2-3 hours to stabilize at normal operating temperatures prior to filling it with fresh or frozen foods.
If operation is interrupted, wait 5 minutes before restarting.
TEMPERATURE CONTROL
REFRIGERATOR
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
||
|
|
|
|
|
The default setting of the temperature control button for the refrigerator compartment is NORMAL.
You can set the refrigerator temperature using the Refrigerator Temperature Control.
Whenever pressing the button, the LED emit light.
The temperature of the compartment is highered as the LED luminesce from MIN to MAX.
You can select the desired set point in five (5) steps between minimum and maximum.
For the economic electricity, set the LED to the MIN position.
|
|
|
|
|
|
|
|
|
|||
|
|
|
|
||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|||||
|
|
|
|
|
|
FREEZER
TEMP.CONTROL
The default setting of the temperature control knob for the freezer compartment is the MID point.
For colder temperatures, adjust the control knob to MAX, and for warmer temperatures, adjust the control knob to MIN position.
5
Loading...