KitchenAid KEWD175HWH1, KEWD175HBL3, KEWD175HWH4, KEWD175HBL1, KEWD175HBL05 Installation Instructions Manual

[] []

Questions regarding features, operation,
performance, parts or service? Call

1o800o461o5681or visit our web site at

www. kitchenaid.com/ca nada.

I(itchen_kid _

FORTHE WAY IT'S MADE _°

Call when you:
[] Have questions about warming oven

installation or operation.

[] Need to obtain the name and number

of an authorized service
company.

When you call, you will need:
[] The warming oven model number.
[] The warming oven serial number.

Both numbers are listed on the
model/serial rating plate, located on the

upper left front corner of the oven cavity.

www.kitchenaid.comlcanada 1-800.461-8681

Readandsa e these

IMPORTANT:
Installer: Leave installation

Instructions with the homeowner.
Homeowner: Keep Installation

Instructions for future reference.
Save Installation Instructions for local

electrical inspector's use.

Write down the model and serial numbers
before installing warming oven.

Both numbers are on the model/serial
rating plate, located on the upper left front

corner of the oven cavity.
Model #

Serial #

Part No. 8300561

Before youstart,,,

Your safety and the safety of
others are very important,

We have provided many important
safety messages in this manual and
on your appliance. Always read and
obey all safety messages.

This is the safety alert
symbol.

This symbol alerts you to
potential hazards that can kill or hurt
you and others.

All safety messages will follow the
safety alert symbol and either the

word "DANGER" or "WARNING".
These words mean:

You can be killed or seriousJy

injured if you don't immediately

follow instructions.

You can be killed or seriously

injured if you don't follow
instructions.

All safety messages will tell you
what the potential hazard is, tell you
how to reduce the chance of injury,
and tell you what can happen if the

instructions are not followed.

important: Observe aJJ governing

codes and ordinances,
Proper installation is your responsibility.

Have a qualified technician install this

oven,

Oven location should be away from
strong draft areas, such as windows,
doors and strong heating vents.

Cabinet opening dimensions that are
shown must be used. Given dimensions

provide minimum ciearance.
Recessed installation area must provide

complete enclosure around the recessed
portion of the oven.

Electrical ground is required. See
"Electrical requirements."

Electrical supply outlet should be
located in the rear wall on the lower right
side of the cutout or in an adjacent

cabinet. The outlet must be recessed. If
the electrical outlet is located in an

adjacent cabinet, provide a 1o3/8"dia.
minimum power supply cord plug

clearance hole in the back of the cutout or
support surface.

Oven support surface MUST be solid,
level and flush with bottom of cabinet

cutout.
There is no provision to level the oven

after it has been installed, If the
installation is not level, the door may

slide open or not seal tightly allowing
heat to escape resulting in poor oven

performance.

It is the customer's responsibility:
To contact a qualified electrical installer,

To assure that the electrical installation is
adequate and in conformance with

National Electrical Code, ANSI/NFPA 70

E latest edition*, or CSA Standards

022.1-94, Canadian Electrical Code, Part 1
and 622 No, 0-M91 E latest edition** and

all local codes and ordinances,

Copies of the standards listed may be obtained

from:

* NationaJ Fire Protection Association

One Batterymarch Park
Quincy, Massachusetts 02269

e* Canadian Electrical Association

178 Rexdale BouJevard
Etobicoke {Toronto), Ontario MSW 1R3

Toolsneededfor Partssupplied:

Phillips

screwdriver

/