KEYENCE CA-LM0307 User Manual

96M11940

Telecentric Macro Lens

CA-LM0307

Precautions

Introduction

This caution sheet describes the precautionary points for using the Telecentric Macro Lens CA-LM0307.
Read this caution sheet before using the product in order to achieve maximum performance.
Keep this caution sheet in a safe place after reading it so that it can be used at any time.

 Symbols

This caution sheet uses the following symbols so that you can recognize important messages at aglance.
Please read it in its entirety.

NOTICE

It indicates a situation which, if not avoided, could result in product damage as well
as property damage.

Precautions Concerning Installation

• When installing this device, always secure the Lens Main Unit side at the specified

• If secured at one spot on the Lens Main Unit side or Camera side only, due to falling etc., an

• This device is a precision device, take preventative measures in an environment

NOTICE

• Use such things as an insulating base when installing the equipment. Ensure that the

• For fixing the Lens Main Unit, do so using the 2 points specified below. If it is fixed using points

Fixing points of the Main Unit

Fix to the surrounding hatching points using the Telecentric Macro Lens dedicated mounting stand or a stand with a
similar structure.

.

points (surrounding 2 points) using the Telecentric Macro Lens dedicated
mounting stand (OP-87524: optional) or a stand with a similar structure.

accident or malfunction may occur and may be the cause of damage. Please do not do so.

where vibration or shock will contact the device. If an environment where vibration
and shock contacting the device continues, it may cause malfunction or damage.

equipment insulation is secured. Since the Lens and the Camera are case grounded,
when there is a difference in potential or there is noise and when installed directly
without secured insulation, it may be the cause of device damage or incorrect operation.

other than those specified, it may cause damage to the Main Unit or interfere with operation.

C-Mount

3.5

ø48

ø41.8

ø40.6

2-M2

M37.5×0.5

113.2

116.8

ø30

ø40

ø39.8

29.1

50

17.526131.7

1

Installation Example of the Telecentric Macro Lens Dedicated Mounting Stand

• Installation example using the Telecentric Macro Lens dedicated mounting stand (OP-87524)

• Dimensional Outline Drawings

68

LENS Center

Stand Main Unit screw positions

70

0.2 2560

80

41.2

(34.5)

(131.7) (48.3)*

130.7

Unit: mm

6.7

* The above shows the dimension when used with CV-035C/M and XG-035C/M.

In the case of the following combinations, the dimension is (60).
When used with CV-200C/M, CV-H035C/M, CV-H100C/M, CV-H200C/M, CV-H500C/M, XG-200C/M,
XG-H035C/M, XG-H100C/M, XG-H200C/M and XG-H500C/M

2012

11940E 1012-1 96M11940

2

2