®
MOUNTING for ‘05 + TOYOTA TACOMA
For TECHNICAL SUPPORT Call:
1-800-343-7486
Monday- Friday 8:00 A.M. to 4:30 P.M. ( PACIFIC )
12”
72” FULL LENGTH BED RAILS
HARDWARE KIT #
4
1"
Slide off
factory T-bolts
31270
Remove factory T-bolts, and
replace with 1”,
1/2” dia Carriage Bolt
12”
Plastic
Cap
USE THESE HOLES AS SHOWN
1-
Remove the 4 rope tie downs that came with your truck by completely unscrewing the knurled tightening knob.
The tightening knob and the plastic tie down bale are separate pieces. Remove plastic cap at the end of the
factory C channel. Remove factory T-bolts. Slide 3 - 1” long x 1/2“ dia carriage bolts (not included) into each C
channel.
2-
The top of the Kargo Master Bed rail has no pre drilled holes. We recommend that you drill a nominal 1/4" dia
hole in the top of each bed rail, about 12" back from each end (total of 4 holes)
Set a bed rail on each side of the truck bed rail. The flange side with the pre drilled holes goes down inside the
3-
truck bed. Align the carriage bolts in the C channel with the pre drilled holes in the bed rails. Use the hole
closest to each end of the bed rail. Slip the Kargo Master bed rail over the threaded studs, so that the studs
protrude out through the holes in the Kargo Master bed rail.
4-
Slide each bed rail as far forward as possible. Secure each bed rail in place by putting a 1/2” lock washer and
1/2“ nut (not included) on each carriage bolt.
5-
Once the bedrails have been tightened in place, we recommend putting a nominal 1/4” sheet metal screw
down through each of the two holes on top of each bed rail. DO NOT OVER TIGHTEN. This will prevent the
rack from sliding back and forth in the C channel.
That's It! - you’re done here, on to the rack.
Loading...